Table of Contents
Advertisement
RUGGEDCOM ROX II
CLI User Guide
• Switch management frames generated by the switch (such as Telnet, HTTP, SNMP, etc.) may not be
mirrored.
The following sections describe how to configure and manage port mirroring:
•
Section 5.16.1, "Configuring Port Mirroring"
•
Section 5.16.2, "Managing Egress Source Ports"
•
Section 5.16.3, "Managing Ingress Source Ports"
Section 5.16.1
Configuring Port Mirroring
To configure port mirroring, do the following:
1.
Make sure the CLI is in Configuration mode.
2.
Navigate to switch » port-mirroring.
3.
Configure port mirroring for a specific port by typing:
switch port-mirroring enabled target-slot slot target-port port egress-src egress ingress-src
ingress
Where:
• slot is the name of the module location
• port is the port number (or a list of ports, if aggregated in a port trunk)
• egress is the port number for the outgoing port
• ingress is the port number for the the incoming port
4.
Add egress and ingress source ports. For more information, refer to
Source Port"
and
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
5.
Section 5.16.2
Managing Egress Source Ports
The following sections describe how to configure and manage egress source ports for port mirroring:
•
Section 5.16.2.1, "Viewing a List of Egress Source Ports"
•
Section 5.16.2.2, "Adding an Egress Source Port"
•
Section 5.16.2.3, "Deleting an Egress Source Port"
Section 5.16.2.1
Viewing a List of Egress Source Ports
To view a list of egress source port for port mirroring, type:
show running-config switch port-mirroring egress-src
Configuring Port Mirroring
Section 5.16.3.2, "Adding an Ingress Source
Section 5.16.2.2, "Adding an Egress
Port".
Chapter 5
Setup and Configuration
265
Advertisement
Table of Contents
Troubleshooting
