Deleting A Port-Specific Multiple Spanning Tree Instances - Siemens RUGGEDCOM ROX II User Manual

RUGGEDCOM ROX II
CLI User Guide
3. Configure the following parameter(s) as required:
Parameter
mstp-priority { mstp-priority }
stp-cost { stp-cost }
rstp-cost { rstp-cost }
4. Map one or more static VLANs and map them to the MSTI. For more information, refer to
"Adding a Static
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
5.
Section 5.36.7.4

Deleting a Port-Specific Multiple Spanning Tree Instances

To delete a Multiple Spanning Tree Instance (MSTI) for a switched Ethernet port or an Ethernet trunk interface, do
the following:
1. Make sure the CLI is in Configuration mode.
2. Delete the MSTI by typing:
• For switched Ethernet ports:
no interface switch slot port spanning-tree msti id
Where:
▪ slot is the name of the module location
▪ port is the port number (or a list of ports, if aggregated in a port trunk) for the module
▪ id is the ID for the Multiple Spanning Tree Instance
Deleting a Port-Specific Multiple Spanning Tree Instances
VLAN".
Description
Synopsis: { 16, 32, 64, 96, 112, 128, 144, 160, 176, 192, 208,
224, 240 }
Default: 128
The STP port priority. Ports of the same cost that attach to a
common LAN will select the port to be used based upon the port
priority.
Synopsis: { auto-cost } or an integer between 0 and 65535
Default: auto-cost
The cost to use in cost calculations, when the cost style
parameter is set to STP in the bridge RSTP parameter
configuration. Setting the cost manually provides the ability to
preferentially select specific ports to carry traffic over others.
Leave this field set to 'auto' to use the standard STP port costs
as negotiated (four for 1Gbps, 19 for 100 Mbps links and 100 for
10 Mbps links). For MSTP, this parameter applies to both external
and internal path costs.
Synopsis: { auto-cost } or an integer between 0 and
2147483647
Default: auto-cost
The cost to use in cost calculations, when the cost style
parameter is set to RSTP in the bridge RSTP parameter
configuration. Setting the cost manually provides the ability to
preferentially select specific ports to carry traffic over others.
Leave this field set to 'auto' to use the standard RSTP port costs
as negotiated (20,000 for 1Gbps, 200,000 for 100 Mbps links and
2,000,000 for 10 Mbps links). For MSTP, this parameter applies
to both external and internal path costs.
Chapter 5
Setup and Configuration
Section 5.37.4.2,
537