Table of Contents
Advertisement
RUGGEDCOM ROX II
CLI User Guide
• community is the route distinguisher for the target VRF to either export the routing table to, import the
routing table from, or both
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
3.
Section 5.22.7
Managing VRF Instances and OSPF
OSPF can be configured for one or more VRF definitions. This is done by by enabling OSPF for a VRF instance
and then configuring the required OSPF parameters.
OSPF can be run on any physical or switched interface, as well as VRF-Lite interfaces (IPv4) and full VRF
interfaces (IP/VPN using MPLS).
The following sections detail how to manage VRF instances and configure OSPF:
•
Section 5.22.7.1, "Viewing a List of VRF Instances"
•
Section 5.22.7.2, "Adding a VRF Instance and Configuring OSPF"
•
Section 5.22.7.3, "Deleting a VRF Instance"
Section 5.22.7.1
Viewing a List of VRF Instances
To view a list of VRF instances defined for OSPF, type:
show running-config routing ospf vrf
If definitions have been configured, a table or list similar to the following example appears:
ruggedcom# show running-config routing ospf vrf
routing ospf
vrf VRF1
enabled
.
.
.
vrf VRF2
enabled
.
.
.
If no VRF definitions have been configured, add definitions as needed. For more information, refer to
Section 5.22.5.2, "Adding a VRF
Section 5.22.7.2
Adding a VRF Instance and Configuring OSPF
To add a VRF instance and configure OSPF, do the following:
1.
Make sure the CLI is in Configuration mode.
2.
Navigate to routing » dynamic » ospf » vrf and configure the following parameter(s) as required:
Managing VRF Instances and OSPF
Definition".
Chapter 5
Setup and Configuration
387
Advertisement
Table of Contents
Troubleshooting
