Managing Hosts; Viewing A List Of Hosts; Adding A Host - Siemens RUGGEDCOM ROX II User Manual

RUGGEDCOM ROX II
CLI User Guide
Section 5.15.9

Managing Hosts

Host entries assign settings to a specific client based on its Ethernet MAC address.
The following sections describe how to configure and manage hosts on a DHCP server:
• Section 5.15.9.1, "Viewing a List of Hosts"
• Section 5.15.9.2, "Adding a Host"
• Section 5.15.9.3, "Configuring Host Options"
• Section 5.15.9.4, "Configuring a Host Client"
• Section 5.15.9.5, "Deleting Hosts"
Section 5.15.9.1

Viewing a List of Hosts

To view a list of hosts on the DHCP server, type:
show running-config services dhcpserver host
If hosts have been configured, a table or list similar to the following example appears:
ruggedcom# show running-config services dhcpserver host APE-INT
services
dhcpserver
host APE-INT
options
hardware mac 00:01:C0:0B:B7:71
fixed-ip
unknown-client allow
subnet
client
hostname APE-INT
no subnetmask
no default-route
no broadcast
no domain
no dns-server
no static-route
no nis server
no nis domain
!
!
!
!
!
If no hosts have been configured, add hosts as needed. For more information, refer to
a Host".
Section 5.15.9.2

Adding a Host

To add a host to the DHCP server, do the following:
1. Make sure the CLI is in Configuration mode.
Managing Hosts
192.168.0.60
SUB2
Chapter 5
Setup and Configuration
Section 5.15.9.2, "Adding
249