Siemens RUGGEDCOM ROX II User Manual page 65

RUGGEDCOM ROX II
CLI User Guide
Parameter
more
nomore
notab
repeat
Using Output Redirects
Description
3: gmtime "Tue Feb 15 08:37:42 2011\n"
localtime "Tue Feb 15 03:37:42 2011\n"
4: software-upgrade
.
.
.
Paginates the output. When the output reaches the screen-length
setting, the CLI prompts you to press a key for more. Press Enter to
advance line-by-line; press space to advance page-by-page.
Suppresses pagination.
Suppresses table output.
For example, show chassis | begin line-modules shows the following
table:
ruggedcom# show chassis | begin line-modules
line-modules
line-module
OVERCURRENT
SLOT DETECTED MODULE
STATUS
----------------------------------------------------------
lm1 1000TX w/ 2x RJ45
lm2 none
lm3 6x RS232/RS422/RS485 via RJ45
lm4 E1 w/ 2x BNC
lm5 none
lm6 none
power-controller
PM MOV PM
SLOT PROTECTION TEMPERATURE
------------------------------------------------
pm1 na 43
For example, show chassis | begin line-modules | notab suppresses
the table formatting:
ruggedcom# show chassis | begin line-modules |
notab
line-modules
line-module lm1
detected module "1000TX w/ 2x RJ45"
line-module lm2
detected module none
line-module lm3
detected module "6x RS232/RS422/RS485 via
RJ45"
line-module lm4
detected module "E1 w/ 2x BNC"
line-module lm5
detected module none
line-module lm6
detected module none
power-controller
PM MOV PM
SLOT PROTECTION TEMPERATURE
------------------------------------------------
pm1 na 43
Repeats the term at the specified interval. Specify an interval in
seconds. The term repeats until you cancel it with Ctrl-C.
Chapter 2
Using RUGGEDCOM ROX II
BYPASS
STATUS
- -
- -
- -
- -
- -
- -
PM PM
CURRENT VOLTAGE
2907 3381
PM PM
CURRENT VOLTAGE
2892 3381
27