Table of Contents
Advertisement
Chapter 5
Setup and Configuration
Parameter
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
5.
Section 5.13.2.3
Deleting a GSM Profile
To delete a GSM Profile, do the following:
1.
Make sure the CLI is in Configuration mode.
2.
Delete the chosen key by typing:
no global cellular profiles gsm name
Where:
• name is the name of the profile
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
3.
Section 5.14
Managing the DHCP Relay Agent
A DHCP Relay Agent is a device that forwards DHCP packets between clients and servers when they are not on
the same physical LAN segment or IP subnet. The feature is enabled if the DHCP server IP address and a set of
access ports are configured.
DHCP Option 82 provides a mechanism for assigning an IP Address based on the location of the client device in
the network. Information about the client's location can be sent along with the DHCP request to the server. Based
on this information, the DHCP server makes a decision about an IP Address to be assigned.
DHCP Relay Agent takes the broadcast DHCP requests from clients received on the configured access port and
inserts the relay agent information option (Option 82) into the packet. Option 82 contains the VLAN ID (2 bytes)
and the port number of the access port (2 bytes: the circuit ID sub-option) and the switch's MAC address (the
remote ID sub-option). This information uniquely defines the access port's position in the network. For example,
in RUGGEDCOM ROX II, the Circuit ID for VLAN 2 on Line Module (LM) 4 Port 15 is 00:00:00:02:04:0F.
The DHCP Server supporting DHCP Option 82 sends a unicast reply and echoes Option 82. The DHCP Relay
Agent removes the Option 82 field and broadcasts the packet to the port from which the original request was
received.
The DHCP Relay Agent communicates to the server on a management interface. The agent's IP address is the
address configured for the management interface.
RUGGEDCOM ROX II can be configured to act as a DHCP Relay Agent that forwards DHCP and BOOTP
requests from clients on one layer 2 network to one or more configured DHCP servers on other networks. This
allows the implementation of some measure of isolation between DHCP clients and servers.
The DHCP Relay Agent is configured to listen for DHCP and BOOTP requests on particular Ethernet and VLAN
network interfaces, and to relay to a list of one or more DHCP servers. When a request is received from a client,
RUGGEDCOM ROX II forwards the request to each of the configured DHCP servers. When a reply is received
from a server, RUGGEDCOM ROX II forwards the reply back to the originating client.
234
Description
The authentication protocol used to establish a cellular data link
RUGGEDCOM ROX II
CLI User Guide
Deleting a GSM Profile
Advertisement
Table of Contents
Troubleshooting
