Table of Contents
Advertisement
RUGGEDCOM ROX II
CLI User Guide
•
Section 5.15.6, "Managing Shared Networks"
•
Section 5.15.7, "Managing Subnets"
•
Section 5.15.8, "Managing Custom Client Options for Subnets"
•
Section 5.15.9, "Managing Hosts"
•
Section 5.15.10, "Managing Custom Host Client Configurations"
•
Section 5.15.11, "Managing Host Groups"
•
Section 5.15.12, "Managing Custom Host Group Client Configurations"
•
Section 5.15.13, "Managing IP Pools"
•
Section 5.15.14, "Managing IP Ranges for Subnets"
•
Section 5.15.15, "Managing IP Ranges for IP Pools"
•
Section 5.15.16, "Managing Option 82 Classes for IP Pools"
Section 5.15.1
Configuring the DHCP Server
To configure the DHCP server, do the following:
1.
Enable the DHCP Server. For more information, refer to
Server".
2.
Add and configure DHCP listen interfaces. For more information, refer to
Listen
Interface".
3.
Add and configure shared networks. For more information, refer to
Network".
NOTE
At least one shared network must be available before a subnet is added.
4.
Add and configure subnets. For more information, refer to
5.
Add and configure hosts. For more information, refer to
6.
Add and configure host-groups. For more information, refer to
Section 5.15.2
Enabling/Disabling the DHCP Server
To enable or disable the DHCP server, do the following:
1.
Make sure the CLI is in Configuration mode.
2.
Enable or disable the DHCP server by typing:
services dhcpserver enabled
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
3.
Configuring the DHCP Server
Section 5.15.2, "Enabling/Disabling the DHCP
Section 5.15.5.2, "Adding a DHCP
Section 5.15.6.2, "Adding a Shared
Section 5.15.7.2, "Adding a
Section 5.15.9.2, "Adding a
Section 5.15.11.2, "Adding a Host
Chapter 5
Setup and Configuration
Subnet".
Host".
Group".
237
Advertisement
Table of Contents
Troubleshooting
