Viewing A List Of Route Map Filters; Viewing A List Of Route Map Filter Entries; Adding A Route Map Filter - Siemens RUGGEDCOM ROX II User Manual

Chapter 5
Setup and Configuration
Section 5.19.3.1

Viewing a List of Route Map Filters

To view a list of route map filters for either dynamic BGP routes, type:
show running-config routing bgp filter route-map
If filters have been configured, a table or list similar to the following example appears:
ruggedcom# show running-config routing bgp filter route-map | tab
TAG SEQ ACTION
OPERATION VALUE
---------------------------------------------------------------------------------------------
map
10 permit
- -
!
If no filters have been configured, add filters as needed. For more information, refer to
an Autonomous System Path
Section 5.19.3.2

Viewing a List of Route Map Filter Entries

To view a list of entries for a route map filter for either BGP, type:
show running-config routing bgp filter route-map tag entry
Where:
• tag is the tag for the route map filter
If entries have been configured, a table or list similar to the following example appears:
ruggedcom# show running-config routing bgp filter route-map map entry | tab
NEXT
SEQ ACTION CALL
OPERATION VALUE
---------------------------------------------------------------------------------------------
10 permit -
- -
!
!
If no filters have been configured, add filters as needed. For more information, refer to
an Autonomous System Path
Section 5.19.3.3

Adding a Route Map Filter

To add a route map filter for dynamic BGP routes, do the following:
318
ON
MATCH AS PREFIX
NEXT ORIGINATOR
CALL GOTO PATH LIST
HOP ORIGIN ID
- - - -
- - -
Filter".
ON
MATCH AS PREFIX
ORIGINATOR
GOTO PATH LIST
HOP ORIGIN ID
- - -
- - -
Filter".
PREFIX PREFIX
LIST LIST METRIC
WEIGHT
- - -
-
PREFIX PREFIX
LIST LIST METRIC
WEIGHT AS
- - -
PEER ORIGIN AS
- - -
Section 5.19.6.3, "Adding
PEER ORIGIN AS IP
- - - -
Section 5.19.6.3, "Adding
Viewing a List of Route Map Filters
RUGGEDCOM ROX II
CLI User Guide
LOCAL
IP PREFERENCE
- -
LOCAL
PREFERENCE
- -