Table of Contents
Advertisement
Chapter 3
Device Management
For information about how to connect to the device via the serial console port, refer to the RUGGEDCOM WIN User
Guide for the RUGGEDCOM WIN7251.
Accessing the Web Interface
The access the Web interface for RUGGEDCOM WIN, do the following:
1.
Connect a PC to the switch/router that is on the same network as the base station.
2.
Open a browser and access the base station via its IP address. The factory default IP address is
192.168.100.100/24.
Section 3.2
Configuring the Base Station
Once the base station is installed and connected to the network, it must be configured. The RUGGEDCOM
WIN7251 features a Web-based User Interface (UI) for all configuration management. For more information about
configuring the base station, refer to the RUGGEDCOM WIN Base Station User Guide associated with the installed
software release.
28
Pin
Name
6
Reserved (Do Not Connect)
7
GND
8
Reserved (Do Not Connect)
RUGGEDCOM WIN7251
Installation Guide
Description
Ground
Configuring the Base Station
Advertisement
Table of Contents
