Module Identification; Smartlinx®Module Type (Read Only); Smartlinx®Protocol (Read Only) - Siemens PROFIBUS DP-V1 Operating Instructions Manual

6. In the catalog, expand the Anybus-s DP-V1 IM item and select the INPUT modules
required.
7. To set up the card, you will need six modules whose combined total byte count must
be 19 Words (38 bytes) of input.
8. Save and compile the hardware configuration and download to the PLC.

Module identification

The following parameters are used together for module identification. Please refer to the
Parameters chapter of your Siemens device operating instructions for more details about
the subject.
3.2.10.4. Smartlinx®Module Type (Read only)
Identifies the module used.
Value
0
1
2
3.2.10.5. Smartlinx®Protocol (Read only)
Identifies the protocol used: the value varies according to the module, and whether it is a
Type 1 or Type 2.
Siemens device
MultiRanger 200 HMI
HydroRanger 200 HMI
MultiRanger 100/200
MultiRanger 100/200
A5E36197302
Module
No module present
Anybus DT module
Anybus S module
Module
PROFIBUS DP-V1
PROFIBUS DP-V1
PROFIBUS DP-V0
DeviceNet
SmartLinx PROFIBUS DP-V1 – Operating Instructions
3.2.10.4.
Smartlinx®Module
Type value
2
2
2
2
3.2.10.5.
Smartlinx®Protocol
value
5
5
1
37
Page 11