Pim-Sm And Passive Mode; Dr Priority - Siemens S223 User Manual

User Manual
SURPASS hiD 6615 S223/S323 R1.5
9.3.1.1
9.3.1.2
A50010-Y3-C150-2-7619

PIM-SM and Passive Mode

You need to open Interface Configuration mode of specified interface for activating PIM-
SM on Ethernet interface. To open Interface Configuration mode, use the following com-
mand.
Command
interface INTERFACE
To disable Interface Configuration mode, use the following command.
Command
no interface INTERFACE
To activate PIM-SM after opening the Interface Configuration mode, use the following
command.
Command
ip pim sparse-mode [ passive ]
The ip pim sparse-mode passive command enables passive mode operation for local
members on the interfaces. Passive mode essentially stops PIM transactions on the inter-
face, allowing only IGMP mechanism to be active. To turn off passive mode, use the ip
pim sparse-mode passive or the ip pim sparse-mode command.
To disable PIM-SM, use the following command.
Command
no ip pim sparse-mode [ passive ]

DR Priority

To set the priority for which a router is elected as the designated router (DR), use the fol-
lowing command in interface configuration mode.
Command
ip pim dr-priority
< 0-4294967294>
no ip pim dr-priority
The router with the highest priority value configured on an interface will be elected as the
DR. If this priority value is the same on multiple routers, then the router with the highest
IP address configured on an interface will be elected as the DR. If a router does not ad-
vertise a priority value in its hello messages, the router is regarded as having the highest
priority and will be elected as the DR. If there are multiple routers with this priority status,
then the router with the highest IP address configured on an interface will be elected as
Mode
Opens Interface Configuration mode of specified inter-
Global
face.
Mode
Global Disables a specified interface.
Mode
Interface Activates PIM-SM on specified interface.
Mode
Interface Disables PIM-SM from specified interface.
Mode
Configures the priority for router.
0-4294967294: priority value
Interface
Returns to the default value 1.
UMN:CLI
Description
Description
Description
Description
Description
305