Tracing Packet Route; Tab. 6.4 Options For Tracing Packet Route - Siemens S223 User Manual

UMN:CLI
6.3.3
98
To perform ping test as the route which the manager designated, use the following steps.
Step 1
Enable IP source-routing function from the equipment connected to PC which the PING
test is going to be performed.
To enable/disable IP source-routing in the hiD 6615 S223/S323, use the following com-
mand.
Command
ip icmp source-route
no ip icmp source-route
Step 2
Performs the ping test from PC as the designate route with the ping command

Tracing Packet Route

You can discover the routes that packets will actually take when traveling to their destina-
tions. To do this, the traceroute command sends probe datagram and displays the round-
trip time for each node.
If the timer goes off before a response comes in, an asterisk (*) is printed on the screen.
Command
traceroute [ADDRESS]
traceroute ip ADDRESS
The following is the basic information to trace packet routes.
Items
Protocol [ip]
Target IP address
Source address
Numeric display [n]
Timeout in seconds [2]
Probe count [3]
Maximum time to live [30]
Port Number [33434]
Options for Tracing Packet Route
Tab. 6.4
SURPASS hiD 6615 S223/S323 R1.5
Mode
Enable IP source-routing function.
Global
Disable IP source-routing function.
Mode
Traces packet routes through the network.
Enable
ADDRESS: IP address or host name
Supports ping test. Default is IP.
Sends ICMP echo message by inputting IP address or host name of
destination in order to check network status with relative.
Source IP address which other side should make a response.
Hop is displayed the number instead of indications or statistics.
It is considered as successful ping test if reply returns within the con-
figured time interval. Default is 2 seconds.
Set the frequency of probing UDP packets.
The TTL field is reduced by one on every hop. Set the time to trace
hop transmission (The number of maximum hops). Default is 30 sec-
onds.
Selects general UDP port to be used for probing Port. The default is
33434. The command of traceroute depends on the port range of des-
tination host up to base + nhops – 1 through the base.
User Manual
Description
Description
Description
A50010-Y3-C150-2-7619