UMN:CLI
7.4.2.8
7.4.2.9
7.4.2.10
7.4.3
7.4.3.1
132
To configure interval of sample inquiry for RMON alarm, use the following command.
Command
sample-interval <0-65535>
Activating RMON Alarm
After finishing all configurations, you need to activate RMON alarm. To activate RMON
alarm, use the following command.
Command
active
Deleting Configuration of RMON Alarm
When you need to change a configuration of RMON alarm, you should delete an existing
RMON alarm.
To delete RMON alarm, use the following command.
Command
no rmon-alarm <1-65535>
Displaying RMON Alarm
To display RMON alarm, use the following command.
Command
show
running-config
alarm
RMON Event
RMON event identifies all operations such as RMON alarm in the switch. You can config-
ure event or trap message to be sent to SNMP management server when sending RMON
alarm.
You need to open RMON Event Configuration mode to configure RMON event.
Command
rmon-event <1-65535>
Event Community
When RMON event is happened, you need to input community to transmit SNMP trap
message to host. Community means a password to give message transmission right.
Mode
Configures interval of sample inquiry.
RMON
(unit: second)
Mode
RMON
Activates RMON alarm.
Mode
Deletes RMON history of specified number, enter the
Global
value for deleting.
Mode
rmon-
All
Shows a configured RMON alarm.
Mode
Opens RMON Event Configuration mode.
Global
1-65535: index number
SURPASS hiD 6615 S223/S323 R1.5
Description
Description
Description
Description
Description
A50010-Y3-C150-2-7619
User Manual