Displaying User Connecting To System; Mac Table - Siemens S223 User Manual

User Manual
SURPASS hiD 6615 S223/S323 R1.5
6.3.4
6.3.5
A50010-Y3-C150-2-7619
The following is an example of tracing packet route sent to 10.2.2.20.
SWITCH# traceroute 10.2.2.20
traceroute to 10.2.2.20 (10.2.2.20), 30 hops max, 38 byte packets
1 10.2.2.20 (10.2.2.20) 0.598 ms 0.418 ms 0.301 ms
SWITCH#

Displaying User Connecting to System

To display current users connecting to the system from a remote place or via console in-
terface, use the following command.
Command
where
The following is an example of displaying if there is any accessing user from remote place.
SWITCH# where
admin at ttyp0 from 10.20.1.32:2196 for 30 minutes 35.56 seconds
admin at ttyS0 from console for 28 minutes 10.90 seconds
SWITCH#

MAC Table

To display MAC table recorded in specific port, use the following command.
Command
show mac BRIDGE [PORTS]
The following is an example of displaying MAC table recorded in default.
SWITCH(config)# show mac 1
port mac addr
==================================================================
eth01 00:0b:5d:98:92:da
eth01 00:14:c2:d9:8a:b5
eth01 00:01:02:50:d6:b9
eth01 00:0d:9d:8c:00:ee
eth01 00:15:00:39:4d:2e
eth01 00:0e:e8:8b:24:ae
eth01 00:14:c2:d9:4c:f0
eth01 00:0b:5d:53:4d:96
eth01 00:13:20:4b:05:af
eth01 00:0e:e8:f0:b3:63
(skipped)
SWITCH(config)#
Mode
Shows current users connecting to the system from a
Enable
remote place or via console interface.
Mode
Enable
Shows MAC table.
Global
BRIDGE: bridge name
Bridge
permission
OK
OK
OK
OK
OK
OK
OK
OK
OK
OK
UMN:CLI
Description
Description
in use
16.62
56.62
72.62
72.62
92.62
115.48
115.48
124.62
132.62
152.62
99