Rip Version - Siemens S223 User Manual

User Manual
SURPASS hiD 6615 S223/S323 R1.5
i
10.3.3
A50010-Y3-C150-2-7619
Command
neighbor A.B.C.D
no neighbor A.B.C.D
You can block the routing information to specific interface by using the passive-interface
command.

RIP Version

Basically, the hiD 6615 S323 supports RIP version 1 and 2. However, you can configure
to receive either RIP v1 type packets only or RIP v2 type packets only.
To configure RIP version, use the following command.
Command
version { 1 | 2 }
no version { 1 | 2 }
The preceding task controls default RIP version settings. You can override the routers RIP
version by configuring a particular interface to behave differently.
To control which RIP version an interface sends, perform one of the following tasks after
opening Interface Configuration mode.
Command
ip rip send version 1
ip rip send version 2
ip rip send version 1 2
To delete the configuration that sends RIP version packet to interface, use the following
command.
Command
no ip rip send version 1
no ip rip send version 2
no ip rip send version 1 2
Similarly, to control how packets received from an interface are processed, perform one of
the following tasks.
Mode
Configures a neighbor router to exchange routing in-
formation.
Router
A.B.C.D: neighbor address
Deletes the neighbor router.
Mode
Selects one type of RIP packets to transmit either RIP
v1 or RIP v2 type packet
Router
Restores the default of specified RIP version type
Mode
Sends RIP v1 type packet only to this interface.
Interface Sends RIP v2 type packet only to this interface.
Sends RIP v1 and RIP v2 type packets both.
Mode
Deletes the configuration of RIP v1 type packet for
helping them to be sent to the interface.
Deletes the configuration of RIP v2 type packet for
Interface
helping them to be sent to the interface.
Deletes the configuration of both RIP v1 and v2 type
packets for helping them to be sent to the interface.
UMN:CLI
Description
Description
Description
Description
363