User Manual
SURPASS hiD 6615 S223/S323 R1.5
10.2.14
10.2.15
A50010-Y3-C150-2-7619
The following example shows how to configure the distance with more than 2 options:
distance ospf external <1-255> inter-area <1-255>
•
distance ospf inter-area <1-255> intra-area <1-255>
•
To make it as a default, use the following command.
Command
no distance ospf
Host Route
OSPF regards routing information of specific host as stub link information. Routing infor-
mation can be assigned to each host which is connected with one router.
To configure the routing information to each host, use the following command.
Command
host A.B.C.D area A.B.C.D
host A.B.C.D area A.B.C.D cost <0-65535>
Command
host A.B.C.D area <1-4294967295>
host A.B.C.D area <1-4294967295> cost <0-
65535>
Passive Interface
The passive interface which is configured by OSPF network operate as stub area. There-
fore passive interface can not exchange the OSPF routing information.
To configure the passive interface, use the following command.
Command
passive-interface INTERFACE
[A.B.C.D]
To release the configured as passive interface, use the following command.
Command
no passive-interface INTERFACE
[A.B.C.D]
Mode
Router
Restores it as the default.
Mode
Router
Mode
Router
Mode
Router
Configures the passive interface.
Mode
Router
Releases the configured as passive interface.
Description
Description
Configures the routing information to
each host.
Description
Configures the routing information to
each host.
Description
Description
UMN:CLI
355