Commands In The Global Configuration Mode; Coordinates Height - Siemens SIMATIC NET Configuration Manual

Configuration
3.1 System
3.1.9

Commands in the global configuration mode

This section describes commands that you can call up in the Global configuration mode.
In Privileged EXEC mode, enter the
Commands relating to other topics that can be called in the Global configuration mode can
be found in the relevant sections.
You exit the Global configuration mode with the
Privileged EXEC mode again.
3.1.9.1

coordinates height

Description
With this command, you enter a height coordinate.
Requirement
You are in the Global Configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
coordinates height <meter>
The parameter has the following meaning:
Parameter
meter
Result
The height coordinate is created.
50
configure terminal
Description
Input box for the height coordinate
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
command to change to this mode.
or command and are then in the
end exit
Range of values / note
max. 32 characters
To use spaces in the entry, enter
the height coordinate in quotes:
coordinates height "123 456"
Configuration Manual, 10/2015, C79000-G8976-C351-05