Default Cost Of Area; Blocking The Transmission Of Routing Information Between Area - Siemens S223 User Manual

User Manual
SURPASS hiD 6615 S223/S323 R1.5
10.2.6.2
!
10.2.6.3
!
A50010-Y3-C150-2-7619

Default Cost of Area

The default cost of Area is configured only in ABR. ABR function is for delivering the
summary default route to stub area or NSSA, in that cases the default cost of area must
be required. However, ABR which does not have stub area or NSSA can not use the fol-
lowing command.
To configure a default cost of Area, use the following command.
Command
<0-4294967295>
area
cost <1-16777215>
To delete a configured default cost of Area, use the following command.
Command
<0-4294967295>
area
cost <1-16777215>
This command is only for ABR which is delivering summary default route to stub or NSSA.

Blocking the Transmission of Routing Information Between Area

ABR transmits routing information between Areas. In case of not to transmit router infor-
mation to other area, the hiD 6615 S323 can configure it as a blocking.
First of all, use the access-list or prefix-list command to assign LIST-NAME. And use
the following command to block the routing information on LIST-NAME. This configuration
only available in case of OSPF router is ABR.
To block routing information on LIST-NAME, use the following command.
Command
area <0-4294967295> filter-list
access LIST-NAME { in | out }
area <0-4294967295> filter-list
prefix LIST-NAME { in | out }
To delete configured blocking information, use the following command.
Command
no area <0-4294967295> filter-
list access LIST-NAME { in | out }
no area <0-4294967295> filter-
list prefix LIST-NAME { in | out }
This command is only available for ABR.
Mode
default-
Router Configures a default cost of Area.
Mode
default-
Router Deletes a configured default cost of Area.
Mode
Router Blocks routing information on LIST-NAME.
Mode
Router Deletes configured blocking information.
UMN:CLI
Description
Description
Description
Description
343