UMN:CLI
3.1.10
!
3.1.11
34
Router Configuration Mode
To open Router Configuration mode, use the following command. The system prompt is
changed from SWITCH(config)# to SWITCH(config-router)#.
Command
router IP-PROTOCOL
Routing functionalities such as RIP, OSPF, BGP, VRRP and PIM-SM are only available for
hiD 6615 S323. (Unavailable for hiD 6615 S223)
According to routing protocol way, Router Configuration mode is divided into BGP, RIP,
and OSPF. They are used to configure each IP routing protocol.
Tab. 3.10 shows a couple of main commands of Router Configuration mode.
Command
distance
neighbor
network
redistribute
Main Commands of Router Configuration Mode
Tab. 3.10
VRRP Configuration Mode
To open VRRP Configuration mode, use the following command. The system prompt is
changed from SWITCH(config)# to SWITCH(config-router)#.
Command
router vrrp INTERFACE GROUP-
ID
Tab. 3.11 shows a couple of main commands of Router Configuration mode.
Command
associate
authentication
preempt
track
vip-access
vr-priority
vr-timers
Main Commands of VRRP Configuration Mode
Tab. 3.11
SURPASS hiD 6615 S223/S323 R1.5
Mode
Global
Opens Router Configuration mode.
Configures distance value to find better route.
Configures neighbor router.
Configures network to operate each routing protocol.
Registers transmitted routing information to another router's table.
Mode
Global
Opens VRRP Configuration mode.
Configures associated IP address same with virtual router.
Configures password of virtual router group.
Activates/deactivates preempt.
Configures VRRP track.
Configures the function of accessing associated IP address.
Assigns priority to virtual router.
Configures advertisement time, which means the interval that master
router distributes its information to another virtual router.
User Manual
Description
Description
Description
Description
A50010-Y3-C150-2-7619