Maximum Number Of Rip Routes; Rip Network Timer - Siemens S223 User Manual

User Manual
SURPASS hiD 6615 S223/S323 R1.5
10.3.10
10.3.11
A50010-Y3-C150-2-7619
To add the value of routing metrics, use the following command.
Command
offset-list ACCESS-LIST { in | out }
<0-16> [INTERFACE]
Command
no offset-list ACCESS-LIST { in |
out } <0-16> [INTERFACE]

Maximum Number of RIP Routes

You can set the maximum number of RIP routes for using on RIP protocol. To set the
maximum number of routes, use the following command.
Command
maximum prefix <1-65535> [1-
100]
no maximum prefix <1-65535>
[1-100]

RIP Network Timer

Routing protocols use several timers that determine such variables as the frequency of
routing updates, the length of time before a route becomes invalid, and other parameters.
You can adjust these timers to tune routing protocol performance to better your internet
needs. The default settings for the timers are as follows.
•
Update
The routing information is updated once every 30 seconds. This is the fundamental
timing parameter of the routing protocol. Every update timer seconds, the RIP proc-
ess is supposed to send the routing table to all neighboring RIP routers.
•
Timeout
The default is 180 seconds. It's the interval of time in seconds after which a route is
declared invalid. However, this information will be still written in routing table until the
neighbor routers are notified that this route is removed from the routing table.
•
Garbage
The invalid information of route is deleted on the routing table every 120 seconds.
Once the information of route is classified as "invalid", it's eventually removed from
the routing table after 120 seconds.
Mode
Add an offset to incoming or outgoing metrics to routes
learned via RIP.
Router ACCESS-LIST: access list name
0-16: type number
INTERFACE: interface name
Mode
Router Removes an offset list.
Mode
Sets the maximum number of routes of RIP.
1-65535: maximum number of RIP routes
1-100: percentage of maximum routes to generate a
Router
warning (default: 75)
Removes the maximum number of routes of RIP which
are set before.
UMN:CLI
Description
Description
Description
369