Creating Igmp Profile; Policy Of Igmp Profile; Group Range Of Igmp Profile - Siemens S223 User Manual

User Manual
SURPASS hiD 6615 S223/S323 R1.5
9.2.8.1
9.2.8.2
9.2.8.3
A50010-Y3-C150-2-7619
dropped, and the port is not allowed to receive IP multicast traffic from that group. If the
filtering action permits access to the multicast group, the IGMP report from the port is
forwarded for normal processing.
IGMP filtering controls only group specific query and membership reports, including join
and leave reports. It does not control general IGMP queries. IGMP filtering has no rela-
tionship with the function that directs the forwarding of IP multicast traffic.

Creating IGMP Profile

You can create or modify the IGMP profile to be used for filtering IGMP join requests from
a port. The system prompt will be changed to SWITCH(config-igmp-profile[N])# from
SWITCH(config)#.
Command
ip igmp profile <1-2147483647>
To delete the created IGMP profile, use the no ip igmp profile <1-2147483647> com-
mand on global mode.
To display the IGMP profile, use the following command.
Command
show ip igmp profile [<1-2147483647>]

Policy of IGMP Profile

Configure the action to permit or deny access to the IP multicast address using the follow-
ing command.
Command
{ permit | deny }

Group Range of IGMP Profile

Configure the group range of IGMP Profile using the following command.
Command
range A.B.C.D [A.B.C.D]
no range A.B.C.D [A.B.C.D]
Mode
Global Configures IGMP profile.
Mode
Enable
Global
Bridge
Mode
IGMP
Configures the action of IGMP profile.
Profile
Mode
Configures a group range.
A.B.C.D: low IP multicast address
IGMP
A.B.C.D: high IP multicast address
Profile
Deletes a configured group range.
Description
Description
Shows IGMP profile.
Description
Description
UMN:CLI
301