Port Traffic; Fan Operation - Siemens S223 User Manual

User Manual
SURPASS hiD 6615 S223/S323 R1.5
6.1.12.2
i
6.1.12.3
!
A50010-Y3-C150-2-7619
To show a configured threshold of CPU load, use the following command.
Command
show cpuload

Port Traffic

To set a threshold of port traffic, use the following command.
Command
threshold port
THRESHOLD { 5 | 60 | 600 } { rx |
tx }
no threshold port PORTS { rx |
tx }
The threshold of the port is set to the maximum rate of the port as a default.
To show a configured threshold of port traffic, use the following command.
Command
show port threshold

Fan Operation

The system fan will operate depending on a configured fan threshold. To set a threshold
of port traffic, use the following command.
Command
threshold fan START-TEMP
STOP-TEMP
no threshold fan
When you set a threshold of fan operation, START-TEMP must be higher than STOP-
TEMP.
To show a configured threshold of fan operation, use the following command.
Command
Enable /Global / Bridge
show status fan
Mode
All Shows a configured threshold of CPU load.
Mode
Sets a threshold of port traffic.
PORTS
PORTS: port number (1/1, 1/2, 2/1, ...)
THRESHOLD: threshold value (unit: kbps)
Global
5 | 60 | 600: time Interval (unit: second)
Deletes a configured threshold of port traffic.
Mode
Enable
Shows a configured threshold of port traffic.
Global
Mode
Sets a threshold of fan operation in the unit of centi-
grade (°C).
START-TEMP: starts fan operation. (default: 30)
Global
STOP-TEMP: stops fan operation. (default: 0)
Deletes a configured threshold of fan operation.
Mode
Shows a status and configured threshold of fan opera-
tion.
UMN:CLI
Description
Description
Description
Description
Description
89