Subnet-Based Vlan; Tagged Vlan - Siemens S223 User Manual

UMN:CLI
8.1.4
8.1.5
182
Command
vlan macbase MAC-ADDRESS
<1-4094>
no vlan macbase
ADDRESS

Subnet-based VLAN

In order to configure VLAN based on Subnet, user should designate Subnet. use the fol-
lowing command.
Command
vlan subne t IP-ADDRESS/M <1-
4094>
no vlan subnet {IP-ADDRESS}
To make precedence between MAC address and Subnet based VLAN, user can choose
one of both with below command.
Command
vlan precedence {MAC / SUB-
NET}

Tagged VLAN

In a VLAN environment, a frame's association with a given VLAN is soft; the fact that a
given frame exists on some physical cable does not imply its membership in any particu-
lar VLAN. VLAN association is determined by a set of rules applied to the frames by
VLAN-aware stations and/or switches.
There are two methods for identifying the VLAN membership of a given frame:
Parse the frame and apply the membership rules (implicit tagging).
•
Provide an explicit VLAN identifier within the frame itself.
•
VLAN Tag
A VLAN tag is a predefined field in a frame that carries the VLAN identifier for that frame.
VLAN tags are always applied by a VLAN –aware device. VLAN-tagging provides a num-
ber of benefits, but also carries some disadvantages.
Mode
Configure VLAN based on MAC address
Bridge
MAC-
Clears configured VLAN based on MAC address.
Mode
Configure VLAN based on Subnet
Bridge
Clears configured VLAN based on Subnet.
Mode
Configure precedence between MAC based
Bridge
VLAN and Subnet based VLAN.
SURPASS hiD 6615 S223/S323 R1.5
Description
Description
Description
A50010-Y3-C150-2-7619
User Manual