Setting The Aux Mix Transition Rate - Sony MVS-8000X User Manual

These settings are linked to the corresponding transition
rate setting operations on each bank.
You can also display and set the fade-to-black transition
rate.
Misc >Transition >Key/ME/FTB menu
The display of the independent key transition rate in the
Misc >Transition >Key/ME/FTB menu (3231) depends on
the selection in the <Key Transition> group of the
Engineering Setup >Switcher >Transition menu (7334) on
each bank.
When [Same] (On direction and Off direction settings
the same) is selected in the <Key Transition>
group: Only "Key" appears.
When [Independ] (On direction and Off direction
settings independent) is selected in the <Key
Transition> group: "Key(On)" and "Key(Off)"
appear.
For details, see "Selecting the independent key transition
mode of the transition control block" (page 446).
Setting the transition rate
To set the M/E transition rate
This section describes setting on the M/E-1 bank as an
example.
1
In the status area of the Misc >Transition >Key/ME/
FTB menu (3231), select [M/E-1].
2
In the <Transition Rate> group, press [Transition].
3
Set the transition rate.
No. Parameter Adjustment
1 Transition Transition rate
Rate
Note
When a clip transition is selected as the transition type, it
is not possible to change the transition rate in the Key/ME/
FTB menu.
To set the independent key transition rate
This section describes setting key 1 to key 4 on the M/E-1
bank as an example.
1
In the status area of the Misc >Transition >Key/ME/
FTB menu (3231), select [M/E-1].
2
In the <Transition Rate> group, press [Key K1-K4].
To insert (on) or remove (off) keys individually, press
[Key(On) K1-K4] or [Key(Off) K1-K4].
3
Set the transition rate.
No. Parameter
1 Key1 Trans
Rate
2
Key2 Trans
Rate
3 Key3 Trans
Rate
4
Key4 Trans
Rate
Setting the fade-to-black transition rate
1
In the Misc >Transition >Key/ME/FTB menu (3231),
press [FTB].
2
Set the transition rate.
No. Parameter
1 Transition
Rate

Setting the AUX Mix Transition Rate

For details about AUX mix transitions, see "AUX Mix
Transitions" (page 94).
1
Open the Misc >Transition >Aux Mix menu (3232).
2
Select the AUX bus (odd-numbered bus) to set.
No. Parameter
1 No
3
Set the transition rate.
No. Parameter
2 Transition
Rate
181
Adjustment
Key 1 transition rate
Key 2 transition rate
Key 3 transition rate
Key 4 transition rate
Adjustment
Transition rate
Adjustment
AUX bus selection
Adjustment
Transition rate