Aux Mix Transitions - Sony MVS-8000X User Manual

AUX Mix Transitions

In addition to M/E and PGM/PST, you can make
transitions between two AUX buses.
Preparing an AUX mix transition
The following preparations are required.
Preparations
Assign the two AUX buses used for the AUX
mix to consecutive odd-numbered and even-
numbered output connectors (for example,
Output 1 and Output 2).
Set the AUX mix transition rate.
Executing an AUX mix transition
Use the [AUX MIX] button on the cross-point Flexi Pad of
the AUX bus control block to execute the transition.
This section describes the use of the AUX1 and AUX2
buses as an example.
Delegation buttons
Cross-point buttons
AUX bus control block
1
In the 1st row or 2nd row in the AUX bus control
block, press the delegation button assigned to the
AUX1 bus, turning it on.
Note
When executing an AUX mix translation, select an
odd-numbered bus. Selecting an even-numbered bus
will not execute an AUX mix transition, even if AUX
mix transitions are enabled.
2
Using the 3rd row or 4th row cross-point buttons,
select the video for before the transition.
3
Press the [AUX MIX] button, turning it on.
Note
To execute an AUX mix transition in the 4th row if
secondary delegation mode is set, use the [2ND AUX
MIX] button, not the [AUX MIX] button.
4
Using the 3rd row or 4th row cross-point buttons,
See page
select the video for after the transition.
page 446
This executes the transition at the preset transition rate.
The video during the transition is output from the
AUX1 bus. The video selected in step 4 is output from
page 181
the AUX2 bus.
AUX MIX button
95