Enabling Aux Mix Transitions; Settings Relating To Video Switching; Selecting The Bank To Configure - Sony MVS-8000X User Manual

Enabling AUX Mix Transitions

An AUX mix transition is enabled by assigning the
combination of AUX buses used in the AUX mix
transition to consecutive odd-numbered and even-
numbered output connectors.
For details about AUX mix transitions, see "AUX Mix
Transitions" (page 94).
Note
When an AUX mix transition is enabled, the video process
and color corrector for the two AUX buses operates with
the settings for the odd-numbered bus.
1
In the Engineering Setup >Switcher >Output menu
(7333), press [Aux Mix].
The Aux Mix menu (7333.12) appears.
2
In the list on the left, select the target odd-numbered
and even-numbered output connectors (for example,
11 and 12).
3
In the list on the right, select the AUX bus combination
to use.
To disable AUX mix transitions, select [Disable].
4
Press [Set].
5
Repeat steps 2 to 4 as required.
6
Press [Execute].
Settings Relating to Video
Switching

Selecting the Bank to Configure

In the Engineering Setup >Switcher >Transition menu
(7334), select the target bank to set and then configure the
bank.
No. Parameter Adjustment
1 Bank Switcher target bank selection
Setting the transition preview mode
In the <Transition Preview> group of the Engineering
Setup >Switcher >Transition menu (7334), select one of
the following.
One Time: The transition preview ends after a single
transition ends.
Normal: Pressing the [TRANS PVW] button switches
between transition preview mode and normal mode.
Selecting the independent key transition
mode of the transition control block
In the <Key Transition> group of the Engineering Setup
>Switcher >Transition menu (7334), select one of the
following.
Same: The transition settings for the on and off directions
are shared.
Independ: The transition settings for the on and off
directions can be set separately.
Selecting the background transition flip-
flop mode
In the Engineering Setup >Switcher >Transition menu
(7334), press [Bus Toggle] to enable (On) or disable (Off)
flip-flop mode.
On: Flip-flop mode
Off: Bus fixed mode
For details, see "Flip-flop mode and bus fixed mode"
(page 87).
Enabling/disabling the fade-to-black
function
In the <FTB> group of the Engineering Setup >Switcher
>Transition menu (7334), select the program output.
To enable fade to black, press [PGM1] to [PGM4], turning
them on.
446