Settings Relating To Signal Inputs; Setting Through Mode; Setting The Video Process - Sony MVS-8000X User Manual

To assign side flag operation buttons to cross-
point buttons
Press [Side Flags Button Assign] to open the Engineering
Setup >Panel >Xpt Assign >Side Flags Button Assign
menu (7322.10) and configure the settings (see page 416).
Settings Relating to
Signal Inputs
You can configure the following inputs.
On the MVS-8000X
• Primary inputs: 1 to 144
• Premium inputs: 145 to 164 (PREM1 to PREM20)
• Format converter dedicated inputs: 165 to 180 (FC1 to
FC16)
On the MVS-7000X
• Primary inputs: 1 to 80
• Inputs converted using format converter: 81 to 88 (FC1
to FC8)

Setting Through Mode

This sets through mode for inputs. You can set this
independently for each primary input or premium input
(MVS-8000X only).
Note
On the MVS-8000X, the format converter dedicated inputs
cannot be set to through mode.
On the MVS-7000X, through mode is disabled for the
input signals which have been converted in the format
converter.
1
In the Engineering Setup >Switcher >Input menu
(7332), select the target input signal to set.
2
To enable through mode, press [Through Mode],
turning it on.

Setting the Video Process

This sets the video process for each input signal, and
adjusts the brightness, hue and so on.
Note
If the color corrector is selected in the Engineering Setup
>Switcher >Key/Wipe/FM/CCR >Bus CCR/Input CCR/
Video Proc menu (7335.3), the video process cannot be
configured.
For details, see "Enabling the Input Signal and AUX Bus
Color Corrector" (page 447).
1
In the Engineering Setup >Switcher >Input menu
(7332), press [Video Process].
The Video Process menu (7332.1) appears.
437