Setting The Independent Key Transition Rate - Sony XVS Series User Manual

Press the [MIX], [WIPE], or [DME WIPE] button,
turning it on.
Setting the independent key transition
type (menu)
This section describes setting the transition type for key 1
on the M/E-1 bank as an example.
1
Open the M/E-1 >Key1 >Transition/Video Process
menu (1117).
2
Select the transition type in the <Transition Type>
group.
If the independent key transition mode is set to
[Independ], select the transition type for key insertion
in the <ON Transition Type> group and the transition
type for key removal in the <OFF Transition Type>
group.
Setting the Independent Key
Transition Rate
There are two ways of setting the transition rate: entering
a value using the numeric keypad control block or using
the Transition/Video Process menu for target key on the
M/E or PGM/PST bank.
You can also display the transition rate, independent key
transition rate, and fade-to-black transition rate for each
bank, and change the settings (see page 174).
When the independent key transition mode is set to
[Independ] in the <Key Transition> group of the
Engineering Setup >Switcher >Transition menu (7334),
you can select the transition type rate when inserting and
removing a key.

Setting the independent key transition rate

(utility/shotbox control block and numeric
keypad control block)
If the independent key transition mode is set to [Independ],
setting the transition rate while a key is not inserted will set
the transition rate for key insertion, and setting the
transition rate while a key is inserted will set the transition
rate for key removal.
1
Press the [TRANS RATE1] to [TRANS RATE3]
buttons in the utility/shotbox control block.
This switches the memory recall buttons to transition
rate display mode.
For details about the [TRANS RATE1] to [TRANS
RATE3] buttons, see "Setting the transition rate
(utility/shotbox control block and numeric keypad
control block)" (page 85).
2
Press a memory recall button displaying the transition
rate to set for the target key, turning it on.
The region name and transition rate appears in the
numeric keypad control block display.
3
Enter the transition rate using the numeric keypad in
the numeric keypad control block.
You can switch the input mode using the [TC] button.
In frame input mode, enter three digits. In timecode
input mode, enter four digits.
To clear the entered value, press the [CLR] button.
4
Press the [ENTER] button.
The input is applied, and the specified value is
reflected in the memory recall button in the utility/
shotbox control block.
To enter a difference value
To set the transition rate by specifying a difference value
from the current value, press the [+/−] button, enter the
difference value, and press the [TRIM] button. Each time
you press the [+/−] button, it toggles between plus (+) and
minus (–).
To check the independent key transition rate
The specified independent key transition rate is displayed
in the independent key transition display section in the
transition control block or independent key transition
control block.
The transition rate for keys assigned to the key delegation
buttons are shown on the display in the key fader control
block.
You can also switch the utility/shotbox control block to
transition display mode to check the transition rate set for
each key.
Setting the independent key transition rate
(menu)
This section describes setting the transition rate of key 1 on
the M/E-1 bank as an example.
1
Open the M/E-1 >Key1 >Transition/Video Process
menu (1117).
2
Select the transition type in the <Transition Type>
group.
If the independent key transition mode is set to
[Independ], select the transition type for key insertion
in the <ON Transition Type> group and the transition
type for key removal in the <OFF Transition Type>
group.
97