Setting Dme Channel Assignments; Setting The Side Flag Material And Operation - Sony MVS-8000X User Manual

1
In the Engineering Setup >Switcher >Config menu
(7331), press [Logical M/E Assign].
The Logical M/E Assign menu (7331.5) appears.
The status area shows the physical M/E and logical M/
E organization.
2
In the <Logical M/E to Physical P/P> group, select one
of the following.
P/P: Assign the physical PGM/PST as logical PGM/
PST.
M/E-1: Assign the physical PGM/PST as logical M/E-
1.
M/E-2: Assign the physical PGM/PST as logical M/E-
2.
M/E-3: Assign the physical PGM/PST as logical M/E-
3.
M/E-4: Assign the physical PGM/PST as logical M/E-
4.
M/E-5: Assign the physical PGM/PST as logical M/E-
5.
Note
[M/E-5] is not displayed on the MVS-8000X.

Setting DME Channel Assignments

You can set DME channels to use on the M/E and PGM/
PST banks for processed keys or DME wipes.
1
In the Engineering Setup >Switcher >Config menu
(7331), press [DME Config].
The DME Config menu (7331.6) appears.
2
Select the target M/E or P/P bank to set.
3
In the <DME Channel> group, select the channel (Ch1
to Ch8) to assign.
4
Repeat steps 2 and 3 as required to make settings for
each M/E and PGM/PST bank.
Setting the Side Flag Material and
Operation
This sets the video material (4:3 aspect ratio) for applying
side flags.
For details about side flags, see "Side Flags" (page 194).
Setting the aspect ratio (4:3 or 16:9)
1
In the Engineering Setup >Switcher >Config menu
(7331), press [Side Flags].
The Side Flags menu (7331.7) appears.
The status area lists the video/key pair numbers, video
signal source names, and aspect ratio settings.
2
Select the target pair number to set.
To select all of the pair numbers, press [ALL].
3
In the <Aspect> group, press [4:3].
If you select [16:9], no side flags are applied.
To set 4:3 video material to have side flags
applied automatically
You can make a setting so that when a signal with aspect
ratio set to 4:3 is selected in the cross-point control block,
side flags are automatically applied.
In the Side Flags menu (7331.7), press [Auto Side Flags],
turning it on.
The settings are common to the M/E and PGM/PST banks.
To set to crop to 4:3 when a DME wipe is executed
When side flags are enabled, you can automatically crop
an image to be a 4:3 image when executing a DME wipe.
In the Side Flags menu (7331.7), press [Auto Crop],
turning it on.
The settings are common to the M/E and PGM/PST banks.
Adjusting the width of the side flags
1
In the Engineering Setup >Switcher >Config >Side
Flags menu (7331.7), press [Width].
2
Set the following parameters.
No. Parameter Adjustment
3 Left
4 Right
5 All
Enabling and disabling side flags
Press a button in the Engineering Setup >Switcher
>Config >Side Flags menu (7331.7) to display the setup
menu.
To enable/disable side flags in the menu
Press [Misc >Enable >Side Flags] to open the Misc
>Enable >Side Flags menu (3213) and configure the
settings (see page 194).
436
Width of left side flag
Width of right side flag
Width of both side flags