Wipe Crop Settings - Sony MVS-8000X User Manual

1
In the DME >Edge >Flex Shadow menu (4115), press
[Flex Shadow], turning it on.
2
In the <Flex Shadow Source> group, select [External].
3
Select [Axis Loc] and set the [Axis Loc V] parameter
so that the center of the flex shadow deformation is at
the bottom of the picture.
(In HD format 16:9 mode: Axis Loc V = –9.00)
It is recommended that the operation is performed by
displaying the flex shadow center axis by enabling
[Flex Shadow Axis] in the DME >Input/Output
>Graphic menu (4164).
4
In the <Invert> group, select [V] to invert the flex
shadow vertically.
5
Select [Size] and set the [Size V] parameter so that the
shadow extends vertically.
(In HD format 16:9 mode: Size V = –1.50)
6
Select [Skew] and set the [Skew H] parameter so that
the parallel lines appear to emerge from the rear at the
right.
(In HD format 16:9 mode: Skew H = –50.00)

Wipe Crop Settings

Notes
• The wipe crop function is not supported on the MVE-
8000A.
• Enabling wipe crop disables any mask that is set.
• When brick is set, wipe crop cannot be enabled. Brick
must be disabled in order to enable wipe crop.
• When [Output] is disabled in the <Shaped Video> group
of the DME >Input/Output >Video/Key menu (4162),
the wipe crop effect cannot be obtained if [Bkgd] is not
enabled in the DME >Input/Output >Bkgd menu (4161).
Applying the wipe crop effect
To select a pattern
1
Open the DME >Edge >Wipe Crop menu (4116).
2
Press [Wipe Crop], turning it on.
3
Press [Pattern Select].
The Pattern Select menu (4116.1) appears.
4
From the displayed patterns (standard wipe patterns 1
to 24 and 304), press any pattern to select it.
You can adjust the size of the pattern using the [Size]
parameter.
To set the pattern size and position
1
In the Wipe Crop menu (4116), press [Position/Size].
2
Set the following parameters.
No. Parameter Adjustment
1 H
2 V
3 Size
5 Pattern
Note
When pattern number 304 is selected, the <Edge>
group effect varies according to the [Size] parameter
setting.
To invert the regions with video signal inserted
and not inserted
In the DME >Edge >Wipe Crop menu (4116), press
[Invert], turning it on.
Setting the aspect ratio of the wipe crop
pattern (Aspect)
1
In the Wipe Crop menu (4116), press [Aspect].
2
Set the following parameters.
No. Parameter Adjustment
1 Aspect
a) When a minus value is specified, the picture is extended in the
vertical direction. When a plus value is specified, the picture is
extended in the horizontal direction.
Rotating the wipe crop pattern (Rotation)
1
In the <Rotation> group of the Wipe Crop menu
(4116), select one of the following.
Angle: Incline the pattern at a fixed angle.
Speed: Rotate the pattern at a set speed.
236
Horizontal position
Vertical position
Pattern size
Pattern number
a)
Aspect ratio