Glow Settings; Mask Settings - Sony MVS-8000X User Manual

No. Parameter Adjustment
1 Luminance Luminance
2 Saturation Saturation
3 Hue Hue
Applying the Fade effect
1
Open the DME >Enhanced Video Modify >Dim &
Fade menu (4173).
2
Press [Fade], turning it on.
3
Set the following parameters.
No. Parameter Adjustment
1 Start Point where fading starts (fade
start point)
2 Gain Degree of fading

Glow Settings

Applying the Glow effect
1
Open the DME >Enhanced Video Modify >Glow
menu (4174).
2
Press [Glow], turning it on.
Notes
• On the MVE-9000 and MKS-7470X/7471X, the key
border function and Glow function cannot be turned
on at the same time. The most recently set function
is enabled.
• On the MVE-8000A, the Defocus and Glow effects
or the Blur and Glow effects cannot be turned on at
the same time. The most recently set function is
enabled.
3
Set the following parameters.
No. Parameter Adjustment
1 Clip
Reference level for highlight
detection
2 Gain Gain level for highlights
3 Soft Softness
4
Press [Matte] and set the glow color.
No. Parameter Adjustment
1 Luminance Luminance
No. Parameter Adjustment
2 Saturation
3 Hue
To invert the highlight areas
Press [Glow Invert], turning it on.
The highlight and non-highlight areas are inverted.
To mask the Glow effect with a selected pattern
Press [Mask] to open the DME >Video Modify >Mask
menu (4127), and set the type of pattern and modifiers (see
page 244).
Note
When the signal format is 1080P on the MKS-7470X/
7471X, masking will cause the edges to become blurred.

Mask Settings

Applying the Mask effect
1
Open the DME >Video Modify >Mask menu (4127).
2
In the <Mask> group, select the effect group you want
to apply the mask.
Effect Gp1: Posterization, Solarization, Nega, Sepia,
Mono, Contrast, Mosaic, Sketch, Metal
Effect Gp2: Defocus, Blur, Glow
Note
On the MVE-8000A, [Effect Gp1] and [Effect Gp2]
cannot be enabled at the same time.
3
Press [Position/Size].
4
Set the following parameters.
No. Parameter Adjustment
1 H
2 V
3 Size
4 Soft
5 Pattern
a) Pattern numbers 21, 24, and 304 (304 cannot be selected on the
MVE-8000A).
5
To invert the mask source, press [Invert], turning it on.
6
Set the modifiers for the mask pattern as required.
244
Saturation
Hue
Horizontal position
Vertical position
Size of mask
Softness of mask
a)
Pattern number