Wiring Settings; Configuring Wiring; Modifying Wiring Settings; Deleting Wiring Settings - Sony MVS-8000X User Manual

Wiring Settings

When configuring a system in which the switcher inputs
and outputs are connected to a router, the connection
configuration (referred to as "wiring") must be set S-Bus
space (inputting physical connection information).
The settings used are common to both parallel and serial
tallies.

Configuring Wiring

1
In the Engineering Setup >Router/Tally >Wiring
menu (7363), press [New].
The New menu (7363.1) appears.
2
Set the destination.
When configuring more than one wiring setting, you
can specify the destination start and end addresses.
No. Parameter Adjustment
1 Destination Destination start address
(From)
2 Destination end address
Destination
(To)
3 Destination Destination level
(Level)
3
Set the source.
No. Parameter Adjustment
4 Source Source start address
(From)
5 Source Source level
(Level)
4
Press [Execute].

Modifying Wiring Settings

1
In the Engineering Setup >Router/Tally >Wiring
menu (7363), press [Modify].
The Modify menu (7363.2) appears.
2
Refer to steps 2 and 3 in "Configuring Wiring"
(page 472) and modify the parameters.
It is not possible to modify the settings for multiple
destinations at the same time. Specify the target
address to modify using the [Destination (Address)]
parameter.
3
Press [Execute].

Deleting Wiring Settings

1
In the Engineering Setup >Router/Tally >Wiring
menu (7363), select the wiring.
2
Press [Delete].

Sorting Wiring Settings

In the Engineering Setup >Router/Tally >Wiring menu
(7363), press [Sort].
The sorting of wiring settings is executed in the following
sequence.
Destination level order (ascending) t Destination
address order (ascending) t Source level order
(ascending)
472