Brick Settings - Sony MVS-8000X User Manual

Note
It is not possible to cross images. If an image is rotated, the
priority is determined by the position on the Z-axis of the
center of the image.
Crossing images
consecutive channels in three dimensions
Note
The three-dimensional crossing function is not supported
on the MVE-8000A.
1
In the Global Effect >Ch1-Ch4 >Combiner Priority
menu (4211), press [Depth], turning it on.
2
Set the following parameters.
For "Ch1+Ch2"
No. Parameter Adjustment
1 Soft Softness of edges of crossed
section
For "Ch1+Ch2+Ch3"
No. Parameter Adjustment
1 Soft1 Softness of edges of channel 1 and
channel 2 crossed section
2 Soft2
Softness of edges of channel 2 and
channel 3 crossed section
For "Ch1+Ch2+Ch3+Ch4"
No. Parameter Adjustment
1 Soft1 Softness of edges of channel 1 and
channel 2 crossed section
2 Soft2
Softness of edges of channel 2 and
channel 3 crossed section
3 Soft3
Softness of edges of channel 3 and
channel 4 crossed section
Crossing images from channels 1 and 2,
and channels 3 and 4 in three dimensions
Note
The three-dimensional cross function is not supported on
the MVE-8000A.
1
In the Global Effect >Ch1-Ch4 >Combiner Priority
menu (4211), press [Combiner1 Depth], turning it on.
2
Set the following parameter.
from up to four
280
No. Parameter Adjustment
1 Soft1 Softness of edges of channel 1 and
channel 2 crossed section
3
Press [Combiner2 Depth], turning it on.
4
Set the following parameter.
No. Parameter Adjustment
1 Soft2 Softness of edges of channel 3 and
channel 4 crossed section

Brick Settings

This allows you to create a cuboid by using images of three
consecutive channels.
The Brick effect can combine Ch1, Ch2, and Ch3, or
combine Ch2, Ch3, and Ch4. The three images are
displayed as shown in the following figure.
Combinations of Ch1, Ch2, and Ch3
Upper side: Ch1 image
Side V: Ch2 image
Side H: Ch3 image
Combinations of Ch2, Ch3, and Ch4
Upper side: Ch2 image
Side V: Ch3 image
Side H: Ch4 image
You can adjust the height of the brick, the overlap between
the three images, and the way to insert the side images.
Creating a Brick
1
Open the Global Effect >Ch1-Ch4 >Brick menu
(4212).
2
Press [Brick], turning it on.
The Brick effect is enabled, and a cuboid (brick)
showing the images of three channels appears.
Adjust parameters for the height of the brick and the
overlap between the three images.