Settings Relating To Signal Outputs; Assigning Output Signals; Adjusting Video Clips; Setting Vertical Blanking Interval Adjustment - Sony MVS-8000X User Manual

Settings Relating to
Signal Outputs
Note
For a format converter dedicated output, Video Clip, V
Blank, Through, Safe Title, and 4:3 Crop cannot be set.

Assigning Output Signals

1
In the Engineering Setup >Switcher >Output menu
(7333), press [Output Assign].
The Output Assign menu (7333.1) appears.
2
In the <Output Assign> group, select one of the
following.
[Re-Entry Source]: The following can duplicated and
assigned.
M/E-1 Output 1 to 6
M/E-2 Output 1 to 6
M/E-3 Output 1 to 6
M/E-4 Output 1 to 6
M/E-5 Output 1 to 6
1)
P/P Output 1 to 6
M/E-1 to 5 Proc Video
P/P Proc Video
M/E-1 to 5 Proc Key
P/P Proc Key
DME Monitor Video
DME Monitor Key
Color Corrector 1, 2
Undefined
Color Bkgd 2
Frame Memory 1 to 8
[Aux Bus]: The following cannot be duplicated and
assigned.
Preset
Edit Preview
AUX1 to 48
1) M/E output signals assigned using the M/E Output Assign menu.
3
Select the output port number and signal to assign.
For output connectors not assigned, press [Inhibit].
4
Press [Set].
1)
1)
1)
1)
1)
443

Adjusting Video Clips

1
In the Engineering Setup >Switcher >Output menu
(7333), press [Video Clip].
The Video Clip menu (7333.2) appears.
2
Select the target output to set.
3
Set the following parameters.
No. Parameter Adjustment
2 White Clip Luminance signal white clip value
3 Dark Clip Luminance signal dark clip value
4 Chrominance signal clip value
Chroma
Clip
To return the parameters to their default settings
Press [Default].
Setting Vertical Blanking Interval
Adjustment and Through Mode
1
In the Engineering Setup >Switcher >Output menu
(7333), press [V Blank/Through].
The V Blank/Through menu (7333.3) appears.
2
Select the target output to set.
3
Press [V Blank Mask], and set the following
parameter.
No. Parameter Adjustment
2 Mask End Final value for vertical blanking
interval
a) The adjustment range varies as follows, depending on the signal
format.
480i: 10 to 19
576i: 6 to 22
1080i/1080PsF: 7 to 20
720P: 7 to 25
1080P: 15 to 41
To return the parameters to their default settings
Press [Default].
4
To enable through mode, press [Through Mode],
turning it on.
The through mode can be enabled for the following
outputs.
• Aux 1 to 48 outputs
• Program outputs of each M/E and PGM/PST bank
• Clean outputs of each M/E and PGM/PST bank
a)