Aux Menu; Setting The Video Process For An Aux Bus; Setting The Color Corrector For An Aux Bus - Sony MVS-8000X User Manual

AUX Menu

You can configure the video process and color corrector
for an AUX bus in the AUX menu.
Setting the Video Process for an
AUX Bus
Note
If the input signal and AUX bus color corrector is enabled
in the Setup menu, the video process of the AUX bus
cannot be used.
For details, see "Enabling the Input Signal and AUX Bus
Color Corrector" (page 447).
1
In the Aux >Aux Bus >Video Process menu (2311),
select the target AUX bus.
Parameter group [2/2]
No. Parameter Adjustment
AUX bus selection
1 AUX Bus
a) When AUX mix transitions are enabled, even-numbered buses
cannot be selected as the target.
2
Press [Video Process], turning it on.
3
Set the following parameters.
No. Parameter Adjustment
1 Video Gain Video signal gain
2 Y Gain Luminance signal gain
3 C Gain Chrominance signal gain
4 Hue Delay Hue delay
5 Black Level Black level
To return the parameters to their default settings
Press [Unity].
Setting the Color Corrector for an
AUX Bus
You can set the following color corrector functions for an
AUX bus with color corrector enabled in the Engineering
Setup >Switcher >Key/Wipe/FM/CCR >Bus CCR/Input
CCR/Video Proc menu (7335.3).
• Video process
• Primary color correction
• RGB clip
Note
If the video process is enabled in the Setup menu, the color
corrector of the AUX bus cannot be used.
For details, see "Enabling the Input Signal and AUX Bus
Color Corrector" (page 447).
1
In the Aux >Aux Bus >CCR menu (2312), select the
target AUX bus.
No.
1
2
In the <CCR> group, press [CCR], turning it on.
The color correction function is enabled for the
selected AUX bus.
Configure each function, as required.
To return color corrector settings to their default
values
Press [Unity] in the <CCR> group, check the message,
then press [Yes].
The parameter settings for each function are restored to
a)
their default values.
Applying the video process effect
In the <Video Process> group of the Aux >Aux Bus >CCR
menu (2312), press [Video Process], turning it on.
For details about the video process, see "Output Video
Process" (page 192).
Applying primary color correction effects
In the <Primary CCR> group of the Aux >Aux Bus >CCR
menu (2312), press [Primary CCR], turning it on.
For details about primary color correction settings, see
"Primary Color Correction" (page 188).
Applying RGB clip effects
In the <RGB Clip> group of the Aux >Aux Bus >CCR
menu (2312), press [RGB Clip], turning it on.
For details about RGB clips, see "RGB Clips" (page 193).
182
Parameter group [2/2]
Parameter Adjustment
AUX Bus AUX bus selection