Sony MVS-8000X User Manual page 442

Field: Conversion in field units
Adaptive: Automatically switching between frame
mode and field mode
When [Adaptive] is selected, set the following
parameter.
No. Parameter Adjustment
Motion detection sensitivity
2 Motion
Select
a) 1: Still priority mode, 2: Standard mode, 3: Motion priority mode
3
In the <Aspect> group, select one of the following.
Edge Crop: Add black bars on the left and right sides
of a 4:3 aspect ratio image to convert it to a 16:9
image.
Letter Box: Crop the top and bottom of a 4:3 aspect
ratio image to convert it to a 16:9 image.
Squeeze: Stretch a 4:3 image horizontally to covert it
to a 16:9 image.
Original image (4:3)
To set the image position in edge crop up-
conversion
1
In the <Edge Crop Position> group of the FC Adjust
menu (7332.2), press [Position], turning it on.
2
Set the following parameter.
No. Parameter Adjustment
2 EC Position Image position
To return the edge crop image to the center
In the <Edge Crop Position> group, press [Center].
To set the image position in letter box up-
conversion
1
In the <Letter Box Position> group of the FC Adjust
menu (7332.2), press [Position], turning it on.
a)
Up-converted image (16:9)
Edge Crop
Letter Box
Squeeze
440
2
Set the following parameter.
No. Parameter Adjustment
2 LB Position Image position
To return the letterbox image to the center
In the <Letter Box Position> group, press [Center].
To configure the enhancer
1
In the FC Adjust menu (7332.2), press [Enhancer],
turning it on.
2
Set the following parameters.
Parameter group [1/2]
No. Parameter Adjustment
2 Detail Gain Adjust the edge enhancement
sharpness
3 Limiter Adjust the maximum signal level to
be added to the original signal
4 Crisp Set the amplitude value for which
low-amplitude signals are not
enhanced
5 Level Set the luminance range for edge
Depend enhancement
Parameter group [2/2]
No. Parameter Adjustment
2 Frequency
Set the central frequency for edge
enhancement
3 H/V Ratio Set the horizontal/vertical ratio for
edge enhancement
Setting the down-converter conversion
method
1
In the Engineering Setup >Switcher >Input >FC
Adjust menu (7332.2), select the target input to set.
2
In the <Aspect> group, select one of the following.
Edge Crop: Crop the left and right sides of a 16:9
image to convert it to a 4:3 image.
Letter Box 13:9: Crop the left and right sides of a 16:9
image to make a 13:9 image and add black bars at
the top and bottom of the 13:9 image to convert it
to a 4:3 image.
Letter Box 14:9: Crop the left and right sides of a 16:9
image to make a 14:9 image and add black bars at
the top and bottom of the 13:9 image to convert it
to a 4:3 image.
Letter Box 16:9: Add black bars on the top and
bottom of a 16:9 image to convert it to a 4:3 image.
Squeeze: Compress a 16:9 image horizontally to
convert it to a 4:3 image.