Setting The Operation Mode Of The [All] Button In The Transition Control Block; Setting Device Control Block Button And Trackball Operation; Setting The Macro Execution Mode - Sony MVS-8000X User Manual

Setting the operation mode when the [RUN]
button is pressed during keyframe effect
execution
In the <Run> group, select one of the following.
Continue: Continue the effect.
Cancel: Cancel the effect, and return to the previous state.
Setting the button display state when executing
an auto transition using the [AUTO TRANS]
button
In the <Auto Trans/Take Key On Stats> group, select one
of the following.
Disable: Lit amber during transition execution, and goes
off at the end of the transition.
Enable: Lit green during transition execution, and at the
end of the transition it is lit red if on-air or lit amber if
not on air.
Note
This setting is only valid in the independent key transition
execution section of the transition control block.
Setting the [TRANS PVW] button operation mode
In the <Trans Pvw> group, select one of the following.
Lock: Pressing the [TRANS PVW] button switches
between transition preview mode and normal mode
each time the button is pressed.
Hold: Transition preview mode is enabled only while the
[TRANS PVW] button is pressed.
The one-time mode setting is set in the Engineering Setup
>Switcher >Transition menu (7334) (see page 446).
Setting the [KEY] button operation mode when a
key source bus is selected
In the <Key Source Bus Select Mode> group, select one of
the following.
Key: The [KEY] button is always lit, and only key signals
are selected using the cross-point buttons.
Video & Key: [KEY] button operation is enabled,
allowing key signals to be selected when lit, and video
signals to be selected when not lit.
Exchanging the [AUTO TRANS] button and [CUT]
button in the transition control block
Press [Auto Trans/Cut Swap], turning it on.
Setting the Operation Mode of the
[ALL] Button in the Transition
Control Block
This sets the next transition selected by the [ALL] button
in the transition control block.
1
In the Engineering Setup >Panel >Operation >Custom
Button menu (7326.4), press [Next Trans All].
The Next Trans All menu (7326.11) appears.
2
In the <Next Trans All> group, select the button for the
next transition.
Note
If all next transition buttons are disabled, the next
transition cannot be set even if the [ALL] button is
pressed.
Setting Device Control Block Button
and Trackball Operation
In the Engineering Setup >Panel >Operation menu (7326),
press [Sensitivity] to open the Sensitivity menu (7326.5).
Configure each function, as required.
Setting the trackball and Z-ring sensitivity in
normal mode
In the <Trackball Normal Mode> group, select one of the
following.
×1: Standard (default travel speed)
×2: Move at 2× speed.
×4: Move at 4× speed.
Setting the trackball and Z-ring sensitivity in fine
mode
In the <Trackball Fine Mode> group, select one of the
following.
1/2: Move at 1/2 speed
1/4: Move at 1/4 speed
1/8: Move at 1/8 speed
Setting the sensitivity when recalling a menu
using double-press
In the <Double Click> group, select one of the following.
Fast: High speed
Normal: Normal
Slow: Low speed

Setting the Macro Execution Mode

1
In the Engineering Setup >Panel >Operation menu
(7326), press [Macro].
The Macro menu (7326.6) appears.
2
In the <Macro Execution Mode> group, select the
macro execution mode.
Normal: Normal execution
Step: Step execution
429