Sony MVS-8000X User Manual page 209

Classification 3M/E mode
Wipes
All M/Es and
P/P
M/E-2
Wipe border M/E-2
M/E outputs M/E-1, M/E-2
Signal selection M/E-1, M/E-2
Utility bus M/E-1
M/E-2
M/E-2
Side flags M/E-2
DMEs M/E-1, M/E-2
P/P
a) When key 1 (key 2) is selected for the next transition and DME wipe is
selected as the transition type, a key 1 (key 2) independent key transition
wipe is subject to restrictions.
b) No restriction is applied to P/P, so both utility buses 1 and 2 can be used.
• Pattern mix cannot be used.
• Pattern number 162 wipes cannot
be used.
• Random/diamond dust wipes
cannot be used.
• Dust mix cannot be used.
• Independent key transition wipes
a)
cannot be used.
Wipe borders are single color only.
OUT5 and OUT6 cannot be used.
PROC V and PROC K signals
cannot be selected using cross-
point buttons.
Since only one utility bus is
available, utility 1 bus is used
instead of utility 2 bus for the
b)
following functions.
• Wipe border
• Preset color mix
• Backgrounds of DME wipes
Since a utility bus is unavailable, a
utility bus cannot be selected for the
following functions.
• Key border
• Sub mask
• Preset color mix
• Wipe border
If a DME wipe which uses a utility
bus for a background image is
selected, a color matte signal is
used instead of a utility bus signal.
Side flags cannot be used.
The same restrictions as those for
4M/E apply.
DMEs can be used in two places for
a dedicated interface, or one place
for an SDI interface.
208
4M/E mode
• Pattern mix cannot be used.
All M/Es and
• Pattern number 162 wipes cannot
P/P
be used.
• Random/diamond dust wipes
M/E-2, M/E-3
cannot be used.
• Dust mix cannot be used.
• Independent key transition wipes
cannot be used.
M/E-2, M/E-3 Wipe borders are single color only.
All M/Es OUT5 and OUT6 cannot be used.
All M/Es PROC V and PROC K signals
cannot be selected using cross-
point buttons.
M/E-1, P/P Since only one utility bus is
available, utility 1 bus is used
instead of utility 2 bus for the
following functions.
• Wipe border
• Preset color mix
• Backgrounds of DME wipes
M/E-2, M/E-3 Since a utility bus is unavailable, a
utility bus cannot be selected for the
following functions.
• Key border
• Sub mask
• Preset color mix
• Wipe border
M/E-2, M/E-3 If a DME wipe which uses a utility
bus for a background image is
selected, a color matte signal is
used instead of a utility bus signal.
M/E-2, M/E-3 Side flags cannot be used.
• For a dedicated interface, DME
All M/Es and
P/P
can be used in only one place for
each M/E.
• For an SDI interface, DME wipes
and processed keys cannot be
used.
• Only one-channel mode patterns
can be selected for DME wipes.
a)