Setting A Link Between M/E Banks; Setting Key Transition Links - Sony MVS-8000X User Manual

5
In the <Video/Button> group, press [Select].
The selected video or button name is reflected in the
status area.
To release a video/button name link
In the <Video/Button> group, press [Clear].
6
Select the target bus to set for the GPI link.
7
In the <Bus> group, select one of the following.
Enable: Enable the GPI link setting for the selected
bus.
Disable: Disable the GPI link setting for the selected
bus.
All Enable: Enable the GPI link setting for all buses.
Setting the delay
1
In the Engineering Setup >Switcher >Link >GPI Link
>GPI Link Adjust menu (7336.5), select the target port
to set and the delay value.
No. Parameter Adjustment
1 GPI Port Target GPI output port to set
5 Delay Delay value for the output port
2
Press [Delay Set].
Setting the re-entry button operation mode
When you select a re-entry button for an M/E bank
(upstream M/E bank) in the cross-point control block of
another M/E bank (downstream M/E bank), the image of
the upstream M/E bank is imported. If a GPI output is
linked to the selected cross-point on the A bus
upstream M/E bank, the system can be set so that it triggers
the GPI output (upstream trigger).
To enable the setting, in the Engineering Setup >Switcher
>Link >GPI Link menu (7336.4), press [Re-Entry Enable],
turning it on.
1) When the bus fixed mode is set, the target bus changes, depending on the
position of the fader lever.
Notes
• Re-entry with this setting enabled is limited to 1 stage
only.
• This setting is common to all GPI output ports.
• This setting is enabled only when a re-entry button is
selected on buses for which GPI link is set to [Enable] in
the GPI Link Adjust menu (7336.5).
• The GPI output is triggered when you press a cross-point
re-entry button, when the re-entry button is selected by
macro execution, or when you press the re-entry button
on the AUX bus remote panel.

Setting a Link Between M/E Banks

The operations which can be linked are as follows.
• Transition execution (auto transition, cut, and fader lever
operation)
• Next transition selection
• Transition type selection
1
In the Engineering Setup >Switcher >Link menu
(7336), press [M/E Link].
The M/E Link menu (7336.6) appears.
The status area displays a link list showing link source
banks and link destination banks (M/E and PGM/
PST), and a selection list.
2
Select the target link number to set.
3
In the <M/E Select> group, select [Master M/E] (link
source).
4
Select the M/E or PGM/PST link source, then press
[M/E Set].
5
In the <M/E Select> group, select [Linked M/E] (link
destination).
6
Refer to step 4 and select the M/E or PGM/PST bank
to make the link destination, and press [M/E Set].
To also link operations other than transition
execution
Press [Transition Only], turning it off.
To release the link
Select the link number and press [Clear].
1)
of the

Setting Key Transition Links

The operations which can be linked are as follows.
• Auto transition
• Key on/off
1
In the Engineering Setup >Switcher >Link menu
(7336), press [Key Trans Link].
The Key Transition Link menu (7336.7) appears.
2
Select the target link number to set.
3
In the <Key Select> group, select [Master Key] (link
source).
4
Select the key for the link source, and press [Key Set].
5
In the <Key Select> group, select [Linked Key] (link
destination).
451