Setting The Input Signal Color Corrector; Setting The Illegal Color Limiter - Sony MVS-8000X User Manual

2
Select the target input signal to set.
3
Press [Video Process], turning it on.
4
Set the following parameters.
No. Parameter Adjustment
1 Video Gain Video signal gain
2 Y Gain Luminance signal gain
3 C Gain Chrominance signal gain
4 Hue Delay Hue delay
5 Black Level Black level
To set the parameter settings to their defaults, press
[Unity].
Setting the Input Signal Color
Corrector
If the color corrector is enabled in the Engineering Setup
>Switcher >Key/Wipe/FM/CCR >Bus CCR/Input CCR/
Video Proc menu (7335.3), the following color corrector
functions for input signals cannot be set.
• Video process
• Primary Color Correction
• RGB Clips
Notes
• Up to 32 inputs can use the color corrector.
• The input signal color corrector cannot be used at the
same time as the AUX bus color corrector.
If inputs with color corrector enabled are selected on an
AUX bus that has color corrector enabled, the input
signal color corrector will have no effect.
• If inputs with color corrector enabled are selected on the
following buses, the input signal color corrector has no
effect.
- CCR 1 and 2 buses
- DME Utility 1 and 2 buses
- Frame memory source 1 and 2 buses
• If inputs with through mode enabled are selected on a
bus that has through mode enabled, the input signal color
corrector will have no effect.
1
In the Engineering Setup >Switcher >Input menu
(7332), press [CCR].
The CCR menu (7332.5) appears.
The remaining number of inputs that can use the color
corrector is displayed in "Free Input CCR."
2
Select the target input to set.
3
In the <CCR> group, press [CCR], turning it on.
The color corrector function is enabled for the selected
input.
Configure each function, as required.
Note
To disable the color corrector for the selected input,
press [CCR], turning it off.
When disabled, the settings of each function of the
color corrector return to their defaults.
To return color corrector settings to their defaults
Press [Unity] in the <CCR> group, check the message,
then press [Yes].
The settings of all parameters for each function are
restored to their defaults.
Applying the video process effect
In the <Video Process> group of the Engineering Setup
>Switcher >Input >CCR menu (7332.5), press [Video
Process], turning it on.
For details about the video process, see "Input Video
Process" (page 188).
Applying the primary color correction
effect
In the <Primary CCR> group of the Engineering Setup
>Switcher >Input >CCR menu (7332.5), press [Primary
CCR], turning it on.
For details about primary color correction settings, see
"Primary Color Correction" (page 188).
Applying the RGB clip effect
In the <RGB Clip> group of the Engineering Setup
>Switcher >Input >CCR menu (7332.5), press [RGB
Clip], turning it on.
For details about RGB clips, see "RGB Clips" (page 193).

Setting the Illegal Color Limiter

This sets the illegal color limiter for the signal generated
by the switcher internal matte generator.
To enable, in the Engineering Setup >Switcher >Input
menu (7332) press [Matte Illeg Col Limit], turning it on.
438