Additional Parameter Data; What This Chapter Contains; Terms And Abbreviations - ABB +N5600 Firmware Instructions

Additional parameter data

What this chapter contains

This chapter lists the parameters with some additional data such as their ranges and
32-bit fieldbus scaling. For parameter descriptions, see chapter
147).

Terms and abbreviations

Term Definition
Actual signal Signal measured or calculated by the drive. Usually can only be monitored
but not adjusted; some counter-type signals can however be reset.
Analog src Analog source: the parameter can be set to the value of another parameter
by choosing "Other", and selecting the source parameter from a list.
Note: The source parameter must be a 32-bit real (floating point) number.
To use a 16-bit integer (for example, received in DDCS data sets) as the
source, data storage parameters
used.
In addition to the "Other" selection, the parameter may offer other pre-
selected settings.
Binary src Binary source: the value of the parameter can be taken from a specific bit
in another parameter value ("Other"). Sometimes the value can be fixed to
0 (false) or 1 (true). In addition, the parameter may offer other pre-selected
settings.
Data Data parameter.
Additional parameter data 503
9
Parameters
47.01...47.08 (see page 368) can be
(page