ABB +N5600 Firmware Instructions page 424

424 Parameters
No. Name/Value
75.42 Acceleration
assistance speed
limit
0.0...100.0 %
75.46 Acceleration
assistance current
0.0...300.0 %
75.50 Kick start enable
Not selected
Selected
DI1
DI2
DI3
DI4
DI5
DI6
DIO1
DIO2
ESP CW bit 5
Other [bit]
75.51 Kick start hold time
0.0...30.0 s
75.52 Kick start speed
reference
4.0...100.0 %
75.56 Kick start current ref
0.0...300.0 %
75.57 Kick start current
ramp
0.0...1000.0 %/s
75.60 Current pulse start
mode enable
Not selected
Selected
DI1
DI2
Description
Defines the speed limit at which acceleration assistance is
automatically disabled.
The assistance current boost is produced only once. If the
speed is below the value set in the parameter, then no
repeated current boost is applied.
Acceleration assistance speed limit.
Defines motor current reference used when the acceleration
assistance routine is active.
Acceleration assistance current.
Defines the source for Kick-start enable signal.
For further information, see section
Kick start enable is inactive.
Kick start enable is active.
Digital input DI1 (10.02 DI delayed
Digital input DI2 (10.02 DI delayed
Digital input DI3 (10.02 DI delayed
Digital input DI4 (10.02 DI delayed
Digital input DI5 (10.02 DI delayed
Digital input DI6 (10.02 DI delayed
Digital input/output DIO1
Digital input/output DIO2
Parameter 74.01 ESP control
enable/disable status of the function.
Source selection (see Terms and abbreviations
Defines the time period for a drive to keep modulating at
speed defined with parameter
reference.
Kick start hold time.
Defines the speed reference used to perform kick-start
routine.
Kick start speed reference.
Defines the motor current reference used when the kick-start
routine is active.
This current produces higher starting torque necessary for the
motor to overcome static friction and starting spinning.
Kick start current ref.
Defines the kick-start reference change rate facilitating
gradual increase of motor current.
Kick start current ramp.
Defines the source for the current pulse-start enable signal.
For further information, see section
48).
Current pulse start mode enable is inactive.
Current pulse start mode enable is active.
Digital input DI1 (10.02 DI delayed
Digital input DI2 (10.02 DI delayed
Kick-start (page 47).
status, bit 0).
status, bit 1).
status, bit 2).
status, bit 3).
status, bit 4).
status, bit 5).
(11.02 DIO delayed status, bit 0).
(11.02 DIO delayed status, bit 1).
word, bit-5 status controls
on page 148).
75.52 Kick start speed
Current pulse-start
status, bit 0).
status, bit 1).
Def/FbEq16
20.0
10 = 1%
100.0
10 = 1%
ESP CW bit 5
0
1
2
3
4
5
6
7
8
9
10
2.0
10 = 1s
4.0
10 = 1%
100.0
10 = 1%
100.0
10 = 1%
ESP CW bit 6
(page
0
1
2
3