Terms And Abbreviations - ABB +N5600 Firmware Instructions

148 Parameters

Terms and abbreviations

Term Definition
Actual signal Type of
contains status information. Most actual signals are read-only, but some (especially
counter-type actual signals) can be reset.
Def (In the following table, shown on the same row as the parameter name)
The default value of a
other macro-specific parameter values, see chapter
Note: Certain configurations or optional equipment may require specific default values.
These are labelled as follows:
(95.20
FbEq16 (In the following table, shown on the same row as the parameter range, or for each
selection)
16-bit fieldbus equivalent: The scaling between the value shown on the panel and the
integer used in communication when a 16-bit value is selected for transmission to an
external system.
A dash (-) indicates that the parameter is not accessible in 16-bit format.
The corresponding 32-bit scalings are listed in chapter
503).
Other The value is taken from another parameter.
Choosing "Other" displays a parameter list in which the user can specify the source
parameter.
Note: The source parameter must be a 32-bit real (floating point) number. To use a 16-bit
integer (for example, received from an external device in data sets) as the source, data
storage parameters
Other [bit] The value is taken from a specific bit in another parameter.
Choosing "Other" displays a parameter list in which the user can specify the source
parameter and bit.
Parameter Either a user-adjustable operating instruction for the drive, or an
p.u. Per unit
parameter that is the result of a measurement or calculation by the drive, or
parameter
bx) = Default changed or write-protected by parameter 95.20, bit x.
47.01...47.08
when used in the Factory macro. For information on
Application macros
Additional parameter data
(page 368) can be used.
(page 131).
(page
actual signal.