Motor Data - ABB +N5600 Firmware Instructions

No. Name/Value
98.15 Position offset user
0...360 deg
99

99 Motor data

99.03 Motor type
Asynchronous
motor
Permanent magnet
motor
SynRM
99.04 Motor control mode
DTC
SMC
99.06 Motor nominal
current
0.0 ... 32767.0 A
Description
Defines an angle offset between the zero position of the
synchronous motor and the zero position of the position
sensor.
This value is initially set by the autophasing routine when
parameter 21.13 Autophasing mode
pulse, and can be fine-tuned later on.
Notes:
• The value is in electrical degrees. The electrical angle
equals the mechanical angle multiplied by the number of
motor pole pairs.
• This parameter is valid only for permanent magnet motors.
Angle offset.
Motor configuration settings.
Selects the motor type.
Note: This parameter cannot be changed while the drive is
running.
Standard squirrel cage AC induction motor (asynchronous
induction motor).
Permanent magnet motor. Three-phase AC synchronous
motor with permanent magnet rotor and sinusoidal BackEMF
voltage.
Synchronous reluctance motor. Three-phase AC
synchronous motor with salient pole rotor without permanent
magnets.
Selects the motor control mode.
Direct torque control. This mode is suitable for most
applications.
Note: For the step-up applications SMC control mode must
be selected.
See also section Operating modes of the drive
Submersible motor control designed with step-up transformer,
sine-filter and long motor cable.
Note: Hardware settings are set separately in group
configuration for the transformation ration settings and
selection of sine-filter type.
Defines the nominal motor current. his setting must match the
value on the rating plate of the motor. If multiple motors are
connected to the drive, enter the total current of the motors.
Notes:
• Correct motor operation requires that the magnetizing
current of the motor does not exceed 90% of the nominal
current of the drive.
• This parameter cannot be changed while the drive is
running.
Nominal current of the motor. The allowable range is 1/6...2 ×
I (nominal current) of the drive (0...2 × I
N
mode).
Parameters 495
is set to Turning with Z-
(page 26).
95 HW
with scalar control
N
Def/FbEq16
0 deg
1 = 1 deg
Asynchro-
nous motor;
SynRM
(95.21 b1);
Permanent
magnet
motor
(95.21 b2)
0
1
2
SMC
0
1
0.0 A
1 = 1 A