ABB +N5600 Firmware Instructions page 235

No. Name/Value
Fieldbus A
Embedded fieldbus
M/F link
Application
Program
ATF
DDCS controller
20.02 Ext1 start trigger
type
Edge
Level
20.03 Ext1 in1 source
Not selected
Selected
DI1
DI2
DI3
DI4
DI5
DI6
DIO1
DIO2
Other [bit]
20.04 Ext1 in2 source
20.05 Ext1 in3 source
Description
The start and stop commands are taken from fieldbus adapter
A.
Note: The start signal is always level-triggered with this
setting regardless of parameter
The start and stop commands are taken from the embedded
fieldbus interface.
Note: The start signal is always level-triggered with this
setting regardless of parameter
The start and stop commands are taken from another drive
through the master/follower link.
Note: The start signal is always level-triggered with this
setting regardless of parameter
The start and stop commands are taken from the application
program control word (parameter
word).
Note: The start signal is always level-triggered with this
setting regardless of parameter
Reserved.
The start and stop commands are taken from an external
(DDCS) controller.
Note: The start signal is always level-triggered with this
setting regardless of parameter
Defines whether the start signal for external control location
EXT1 is edge-triggered or level-triggered.
Note: This parameter is only effective when parameter
Ext1 commands is set to
fwd; In2 Start rev, or Control
The start signal is edge-triggered.
The start signal is level-triggered.
Selects source 1 for parameter
0 (always off).
1 (always on).
Digital input DI1 (10.02 DI delayed
Digital input DI2 (10.02 DI delayed
Digital input DI3 (10.02 DI delayed
Digital input DI4 (10.02 DI delayed
Digital input DI5 (10.02 DI delayed
Digital input DI6 (10.02 DI delayed
Digital input/output DIO1
Digital input/output DIO2
Source selection (see Terms and abbreviations
Selects source 2 for parameter
For the available selections, see parameter
source.
Selects source 3 for parameter
For the available selections, see parameter
source.
20.02 Ext1 start trigger
20.02 Ext1 start trigger
20.02 Ext1 start trigger
06.02 Application control
20.02 Ext1 start trigger
20.02 Ext1 start trigger
In1 Start, In1 Start; In2 Dir,
panel.
20.01 Ext1 commands.
status, bit 0).
status, bit 1).
status, bit 2).
status, bit 3).
status, bit 4).
status, bit 5).
(11.02 DIO delayed status, bit 0).
(11.02 DIO delayed status, bit 1).
on page 148). -
20.01 Ext1 commands.
20.03 Ext1 in1
20.01 Ext1 commands.
20.03 Ext1 in1
Parameters 235
Def/FbEq16
12
type.
14
type.
15
type.
21
type.
22
16
type.
Edge
20.01
In1 Start
0
1
DI1
0
1
2
3
4
5
6
7
10
11
Not selected
Not selected