ABB +N5600 Firmware Instructions page 397

No. Name/Value
60.17 Follower fault action
No action
Warning
Fault
60.18 Follower enable
MSW bit 0
MSW bit 1
MSW bits 0 + 1
Always
MSW bit 12
MSW bits 0 + 12
MSW bits 1 + 12
Description
(Effective in the master only.) Selects how the drive reacts to
a fault in a follower.
See also parameter 60.23 M/F status supervision sel
Note: Each follower must be configured to transmit its status
word as one of the three data words in parameters
61.01...61.03. In the master, the corresponding target
parameter (62.04...62.12) must be set to
No action taken. Unaffected drives on the master/follower link
will continue running.
The drive generates a warning
Drive trips on FF7E Follower. All followers will be stopped.
Interlocks the starting of the master to the status of the
followers.
See also parameter 60.23 M/F status supervision sel
Note: Each follower must be configured to transmit its status
word as one of the three data words in parameters
61.01...61.03. In the master, the corresponding target
parameter (62.04...62.12) must be set to
The master can only be started if all followers are ready to
switch on (bit 0 of 06.11 Main status word
on).
The master can only be started if all followers are ready to
operate (bit 1 of 06.11 Main status word
on).
The master can only be started if all followers are ready to
switch on and ready to operate (bits 0 and 1 of
status word in each follower are on).
The starting of the master is not interlocked to the status of
the followers.
The master can only be started if user-definable bit 12 of
06.11 Main status word
06.31 MSW bit 12 sel.
The master can only be started if both bit 0 and bit 12 of
Main status word in each follower are on.
The master can only be started if both bit 1 and bit 12 of
Main status word in each follower are on.
Follower
(AFE7 Follower).
Follower
in each follower is
in each follower is
06.11 Main
in each follower is on. See parameter
Parameters 397
Def/FbEq16
Fault
1.
SW.
0
1
2
Always
1.
SW.
0
1
2
3
4
06.11 5
06.11 6