D2D And Ddcs Transmit Data - ABB +N5600 Firmware Instructions

406 Parameters
No. Name/Value
Warning
Fault
61
61 D2D and DDCS
transmit data
61.01 M/F data 1
selection
None
CW 16bit
SW 16bit
Act1 16bit
Act2 16bit
Follower CW
Used speed
reference
Torque reference
act 5
Torque reference
used
ACS800 System
ctrl SW
Other
61.02 M/F data 2
selection
61.03 M/F data 3
selection
61.25 M/F data 1 value
0...65535
Description
The drive generates a warning
Drive trips on 7580 INU-LSU comm
Defines the data sent to the DDCS link.
See also parameter group
Preselects the data to be sent as word 1 onto the
master/follower link.
See also parameter 61.25 M/F data 1
Master/follower functionality
None.
Control Word (16 bits)
Status Word (16 bits)
Actual value ACT1 (16 bits)
Note: Using this setting to send a reference to the follower is
not recommended as the source signal is filtered. Use the
"reference" selections instead.
Actual value ACT2 (16 bits)
Note: Using this setting to send a reference to the follower is
not recommended as the source signal is filtered. Use the
"reference" selections instead.
A word consisting of bits 0...11 of
and the bits selected by parameters 06.45...06.48.
Note: Bit 3 of the follower control word is kept on as long as
the master is modulating, and when it switches to 0, the
follower coasts to a stop.
24.01 Used speed reference
26.75 Torque reference act 5
26.02 Torque reference used
A follower status word compatible with an ACS800 (System
Control Program) master. With this setting, status word bit 0 is
cleared whenever the run enable signal is missing.
Source selection (see Terms and abbreviations
Preselects the data to be sent as word 2 onto the
master/follower link.
See also parameter 61.26 M/F data 2
For the selections, see parameter
Preselects the data to be sent as word 3 onto the
master/follower link.
See also parameter 61.27 M/F data 3
For the selections, see parameter
Displays the data to be sent onto the master/follower link as
word 1 as an integer.
If no data has been preselected by
selection, the value to be sent can be written directly into this
parameter.
Data to be sent as word 1 in master/follower communication.
(AF80 INU-LSU comm
loss.
60 DDCS communication.
value, and section
(page 68).
06.01 Main control word
(page 263).
(page 285).
(page 279).
on page 148). -
value.
61.01 M/F data 1
value.
61.01 M/F data 1
61.01 M/F data 1
Def/FbEq16
loss). 1
2
Follower CW
0
1
4
5
6
27
6145
6731
6658
28
Used speed
reference
selection.
Torque
reference act
5
selection.
0