Standard Ai - ABB +N5600 Firmware Instructions

196 Parameters
No. Name/Value
11.60 Freq out 1 at src
min
0...16000 Hz
11.61 Freq out 1 at src
max
0...16000 Hz
11.81 DIO filter time
0.3 ... 100.0 ms
12

12 Standard AI

12.01 AI tune
No action
AI1 min tune
AI1 max tune
AI2 min tune
AI2 max tune
12.03 AI supervision
function
No action
Fault
Warning
Last speed
Description
Defines the minimum value of frequency output 1. See
diagrams at parameter 11.58 Freq out 1 src
Minimum value of frequency output 1.
Defines the maximum value of frequency output 1. See
diagrams at parameter 11.58 Freq out 1 src
Maximum value of frequency output 1.
Defines a filtering time for parameter
filtering time will only affect the DIOs that are in input mode.
Filtering time for 11.01.
Configuration of standard analog inputs.
Triggers the analog input tuning function.
Connect the signal to the input and select the appropriate
tuning function.
AI tune is not activated.
Current analog input AI1 signal value is set as minimum value
of AI1 into parameter 12.17 AI1
to No action automatically.
Current analog input AI1 signal value is set as maximum
value of AI1 into parameter
back to No action automatically.
Current analog input AI2 signal value is set as minimum value
of AI2 into parameter 12.27 AI2
to No action automatically.
Current analog input AI2 signal value is set as maximum
value of AI2 into parameter
back to No action automatically.
Selects how the drive reacts when an analog input signal
moves out of the minimum and/or maximum limits specified
for the input.
The supervision applies a margin of 0.5 V or 1.0 mA to the
limits. For example, if the maximum limit for the input is
7.000 V, the maximum limit supervision activates at 7.500 V.
The inputs and the limits to be observed are selected by
parameter 12.04 AI supervision
Note: Analog input signal supervision is only active when
• the analog input is set as the source (using the
or AI2 scaled selection) in parameter 22.11, 22.12, 22.15,
22.17, 23.42, 26.11, 26.12, 26.16, 26.25, 28.11, 28.12,
30.21, 30.22, 40.16, 40.17, 40.50, 41.16, 41.17,
44.09, and is being used as the active source, or
• supervision is forced using parameter
force.
No action taken.
Drive trips on 80A0 AI supervision.
Drive generates an A8A0 AI supervision
Drive generates a warning
the speed (or frequency) to the level the drive was operating
at. The speed/frequency is determined on the basis of actual
speed using 850 ms low-pass filtering.
WARNING! Make sure that it is safe to continue
operation in case of a communication break.
min.
min.
11.01 DIO status. The
min. The value reverts back
12.18 AI1 max. The value reverts
min. The value reverts back
12.28 AI2 max. The value reverts
selection.
AI1 scaled
12.05 AI supervision
warning.
(A8A0 AI supervision) and freezes
Def/FbEq16
0 Hz
1 = 1 Hz
16000 Hz
1 = 1 Hz
10.0 ms
10 = 1 ms
0
1
2
3
4
No action
41.50 or
0
1
2
3