Licensing; Safety Instructions; Target Audience - ABB +N5600 Firmware Instructions

14 Introduction to the manual

Licensing

The ESP control program (+N5600), version AESLx 1.00 or later comes with a
license key on the ZMU-02 memory unit. The program activates only after
recognizing the key and correspondingly registers itself with the ESP software.
Device
ZMU-02 memory unit license key
ESP software (loading package)
You can see the license information in the Drive Composer PC tool or in the ACS-APx
control panel from System info -> Licenses.
If the program was loaded to a ZMU-02 memory unit without the license key, then the
drive indicates a fault
logger to know the plus code of the missing license, in this case N8019. For further
assistance, contact your local ABB representative.

Safety instructions

Follow all safety instructions delivered with the drive.
• Read the complete safety instructions before you install, commission, or use
the drive. The complete safety instructions are delivered with the drive as either
part of the Hardware manual, or, in the case of ACS880 multidrives, as a separate
document.
• Read the firmware function-specific warnings and notes before changing
parameter values. These warnings and notes are included in the parameter
descriptions presented in chapter Parameters.

Target audience

This manual is intended for people who design, commission, or operate the drive
system.
64A5 Licensing fault. See the auxiliary fault code in the Event
License key
N8019 MU Interlock key - Oil lifting
N8020 Licensed appl Oil lifting