ABB +N5600 Firmware Instructions page 171

No. Name/Value
06.20 Constant speed
status word
Bit Name
0 Constant speed 1
1 Constant speed 2
2 Constant speed 3
3 Constant speed 4
4 Constant speed 5
5 Constant speed 6
6 Constant speed 7
7...15 Reserved
0000h...FFFFh
06.21 Drive status word 3
Bit Name
0 DC hold active
1 Post-magnetizing
active
2 Motor pre-heating
active
3 Smooth start active
4 Rotor position known
5...15 Reserved
0000h...FFFFh
Description
Constant speed/frequency status word. Indicates which
constant speed or frequency is active (if any). See also
parameter 06.19 Speed control status
Constant speeds/frequencies
This parameter is read-only.
Description
1 = Constant speed or frequency 1 selected
1 = Constant speed or frequency 2 selected
1 = Constant speed or frequency 3 selected
1 = Constant speed or frequency 4 selected
1 = Constant speed or frequency 5 selected
1 = Constant speed or frequency 6 selected
1 = Constant speed or frequency 7 selected
Constant speed/frequency status word.
Drive status word 3.
This parameter is read-only.
Description
1 = DC hold is active (see par. 21.08)
1 = Post-magnetizing is active (see par. 21.08)
1 = Motor pre-heating is active (see par. 21.14)
Reserved.
1 = Rotor position has been determined (autophasing not
needed). See section
Drive status word 3.
word, bit 7, and section
(page 80).
Autophasing (page 96).
Parameters 171
Def/FbEq16
-
1 = 1
-
1 = 1